SimpliFire SF-25 User manual

Electric Fireplace Stove
Model# SF-25
CONSUMER SAFETY INFORMATION
⚫Read this manual before installing and operating this appliance
⚫Failure to follow these instructions may result in electric shock, fire property, or
personal injury
⚫Do not store or use gasoline or other flammable liquids in vicinity of this
appliance.
-1-
Getting Started
⚫Remove the appliance from the box.
⚫Remove any packaging from the product.
⚫Place the packaging inside the box and either store or dispose of safely.
Contents of Carton
⚫Heater
⚫1 Instruction Manual
⚫Four Legs
⚫8 pcs of 4*12mm screws
⚫Before operating this unit, please read these instructions completely and save them
for the future use.
⚫This appliance is not intended for use by persons ( including children ) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
⚫Children should be supervised to ensure that they do not play with the appliance.
⚫In order to avoid any danger, the cable must be changed by the special person from
manufacture, maintain department or relative department if the cable there is any
broken.
-2-

Assembling
Insert the leg buckles into the holes located on the base of the stove. Fasten the legs using
the screws ( 1 screw per leg ) and tighten with a Phillips head screwdriver, as followed
picture.
Operation Procedure
ON/OFF ------POWER
The power switch supplies power to all of the functions of the fireplace and will illuminate
the flame effect. This switch must be lit for any of the functions to work.
HEAT I
Low heater, Turn on this button the power is 750W.
HEAT II
HIGH heater, Turn on this button the power is 1500W.

Temperature control
Adjust temperature as your needed.
Flame adjustment
Adjust flame brightness as your needed.
Flame Adjustment
Adjust the flame from the bright to dark according to your choice
Temperature Control .
Temperature regulated heater ensures the appliance will not overheat. Should the heater
reach an unsafe temperature, the heater will automatically off. As the heater reach the safe
temperature, the heating function will work again.
Safety Instruction
-5
When using appliance, basic safety precautions should always be followed:
1. Check that the voltage indicates on the data plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
2. This appliance is not intended for use by persons ( including children ) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
3. Children should be supervision to ensure that they do not play with the appliance.
4. If the supply cord is damaged, it must be replaced by a qualified engineer on order
to avoid hazard.
5. The appliance must not be located immediately below a socket outlet.
6. Keep furniture, curtains and other flammable material at least one meter away
from the appliance.
7. Keep out of reach of children and do not allow them to operate this appliance.
8. Do not operate this appliance after a malfunction or after being dropped or
damaged in any way.
Cleaning:
⚫Turn heater OFF and unplug from electrical outlet before any cleaning or
maintenance is performed. Wait at least 10 minutes to allow all components to
cool properly.
⚫Use a vacuum or duster to keep heater and vent area clean from dust and dirt.
⚫The exterior of the fireplace should be cleaned with a damp cloth or duster.
Do not use abrasive cleaners or liquid sprays.
-6-

WARNINGS AND CAUTIONS
WARNING To avoid electrical shock not open the back panel of the insert
unless the Power has been turned off.And the insert has been unplugged.
WARNING Any electrical repairs.to this electric fireplace. Should only be
Performed by a qualified technician.
WARNING Any electrical wiring repairs should only be performed by a
qualified Technician.And also must comply with local buildings codes.
WARNING Discontinue use of this electric fireplace if any of the follow has
Occurred: Water damage. If insert has been or dented. If power
cord has Become broken. If power cord becomes hot to touch, if unit smokes or Smells
like smoke.
Note: When the heat functions is used for the first time.Aslight odor may be
Present. This is normal and should be occur again unless heater is not
used For extended periods of time and dust is allowed to accumulate on heater
Element.
Technical Specification
Supply: 120V-60Hz
Rated power:1500W
-7-
Safety Cut-Off
⚫This appliance is fitted with a safety cut-off which will operate if the fire
overheats (e.g. due to blocked air vents) .For safety reasons, the fire will NOT
automatically reset.
⚫To reset the appliance, disconnect the appliance from the mains supply for at
least 15 minutes. Reconnect the supply to the mains and switch on the appliance.
Troubleshooting
Symptom
Solution
No operation/no fan,
Check fuse by replacement,
Check for safety cut-off operation,
No fire effect light,
Check the LED light with
technician.
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact you local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can
leak into the groundwater and get into the food chain, damaging your health and
well-being.
When replacing old appliances with new ones, the retailer is legally obligated to
take back your old appliance for disposals at least free of charge.
-8-