SimpliFire SF-ALL60-BK User manual

1
SimpliFire • SF-MEDIA-LOGS Instructions • 2040-935 • 3/18
SF-MEDIA-LOGS
Model: SF-ALL48-BK, SF-ALL60-BK
Instructions
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation and service. Sheet metal edges are sharp.
Leave this instruction with party responsible for
use and operation.
NOTICE! DO NOT discard these instructions. Important
service and maintenance instructions included.
NOTICE! DO NOT discard any hardware while
servicing. It may be reused.
WARNING! Risk of Shock! Always unplug the cord or
turn off the circuit breaker before moving or servicing.
Tools and Supplies Needed
Before beginning the installation be sure that the following
tools - supplies are available.
Gloves
Magnetic Phillips screwdriver
Safety glasses
Crystal Media (included with appliance)
Glass Front Removal
Remove Glass Front
1. Remove the two (2) ST3X8 screws located on the
glass panel. See Figure 1.
Note: Do not discard screws, screws will be reused.
2. Lift up evenly on the bottom edge of the glass to
disengage the J-hooks from the shoulder bolts on the
appliance.
CAUTION! Two adults recommended for the removal
or installation of glass front. Use caution when han-
dling glass. Failure to do so could result in personal injury
or property damage.
Figure 1. Remove Glass Front
Kit includes:
LOG
REFERENCE
LETTER
LOG
QUANTITY
A 2
B 1
C 1
D 1
E 1
F 1
G 3
H 2

SimpliFire • SF-MEDIA-LOGS Instructions • 2040-935 • 3/182
Log Installation
3. Place small logs G (3) and H (2) on the fuel bed as show in Figure 2 & 4.
Figure 2. Place Small Logs
G G G
(SF-ALL-60-BK ONLY)
HH
4. Place medium logs A (2), B (1), C (1), D (1), E (1) and F (1) on the fuel bed as show in Figure 3 & 4.
Note: You may not need to use all the logs on the SF-ALL48-BK.
Figure 3. Place Medium Logs
CD EF AB
Figure 4. Log Placement Reference per Appliance
A
(SF-ALL-60-BK ONLY)
5. Place the small clear crystal media (included with the appliance) in between the log layout as show in Figure 5..
Figure 5. Place Small Clear Crystal Media

3
SimpliFire • SF-MEDIA-LOGS Instructions • 2040-935 • 3/18
Glass Front Installation
Installing Glass
6. Install front panel. Locate the J-hooks on the back
side of the glass on the four shoulder bolts on the
appliance opening. Engage the shoulder bolts.
See Figure 6.
7. Press down on top edge of glass to fully engage J-
hooks on the shoulder bolts.
Note: Make sure the glass is fully attached to the re-
box so that the control panel can work properly.
Figure 6. Glass Front Removal/Installation
8. Thread the two (2) ST3X8 screws into the threaded
holes on the glass panel. Check the alignment of
the glass panel and securely tighten the screws. See
Figure 7.
SimpliFire, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
Please contact the SimpliFire customer/technical
support hotline at 877-320-0730 with any questions
or concerns.
Figure 7. Secure Glass Front