Sirius Satellite Radio Model Satellite User manual

SIRIUS"
SIRIUS Satellite Radio
User Manual

Thank you for purchasing this product.
*Please read this user's manual in its entirety before operating this equipment.
*After reading this manual, be sure to keep it in ahandy place (e.g., glove compartment).
*Checkthe contents ofthe enclosed warranty card and keep it carefully with this manual.
Contents
1. FEATURES 1
2. PRECAUTIONS 2
3. INSTALLATIONAND
WIRING CONNECTIONS 4
4. SYSTEM EXAMPLES 7
5.
CONTROLS 9
6. SIRIUS OPERATION 11
7. SPECIFICATIONS 15
1. FEATURES
•CeNET Connection
•RCA Output
•Switching for Headunit
or Commander operation
•Connection of DSC920S (Exclusive Commander) for operation when
using with other line level input devices
•Single Antenna Terminal
•18 Channel presets when used with CeNet devices
• CD~Changer pass-through function

2. PRECAUTIONS
1. Upon initial startup or when starting
after turning off the backup power
supply, the receiver will take longer to
play audio and may take
up to 30
seconds after reception of the SIRIUS
signal before audio
is heard.
2. Channel names are stored in memory
30 to 60 seconds after start
of normal
operation. If the power
is turned off
before the text data
is written, it may
not be correctly displayed
on the next
power up. Perform areset operation if
no text data is displayed.
3. Ifthe receiver ever stops functioning or
appears unresponsive, reset it.
•Resetting: Disconnect the SIRIUS
Receiver power cable (the CeNET
cable if connected to the CeNET and
the 4-pin power cable during
standalone operation), wait 10
seconds and connect it again. The last
channel, preset memory and other
data stored
in the receiver are deleted
returning it to its default settings.
4. ACeNET and standalone operation
switch is provided on the underside of
the receiver. The switch
is set to
CeNET position at the time
of
shipment. Do not set this switch to the
standalone position when using the
CeNET cable (headunit operation).
5. The receiver becomes warm during
operation; this is normal and not a
cause for concern.
6. Do not touch the connector pins on the
receiver
as this may damage the ICs
inside the unit.
7. No station is selected when the [adjJ or
[disp] button is pressed quickly after a
channel
is changed. This is because
button operations are not accepted
until the channel
is confirmed. It takes
between 1.5 to 5seconds to change
channels.
2
This equipment has been tested to comply
with the limits for aClass 8digital device,
pursuant to Part 15
of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference
in aresidential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used
in accordance with the
instructions, may cause harmful
interference to radio communications. '
However, there
is no guarantee that
interference will not occur
in aparticUlar
installation.
Ifthis equipment does cause harmful
interference to radio or television reception,
which can
be determined by turning the
equipment off and on, the user
is
encouraged to consult the dealer or an
experienced radio/TV technician for help.
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN, MAY
RESULT
IN HAZARDOUS RADIATION
EXPOSURE.
THE COMPACT DISC PLAYER or
COMMANDER SHOULD NOT BE
ADJUSTED OR REPAIRED BY ANYONE
EXCEPT PROPERLY QUALIFIED SERVICE
TECHNICIANS.
CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE
MANUFACTURER FOR COMPLIANCE
COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE
MANUFACTURER WILL VOID THE
WARRANTY AND WILL VIOLATE FCC
APPROVAL.

SIRIUS"
What is SIRIUS Satellite
Radio?
Over 100 streams of the best in-car
entertainment and completely
commercial-free music
Only SIRIUS has 60 original music
streams, from today's hits to R&B
oldies to classical masterpieces. From
authentic country and real bluegrass to
cool jazz, hot latin, reggae, rock, and
many more. Best of all, it's all
commercial free, aSirius exclusive.
Sirius also has over 40 streams of
world-class sports, news and
entertainment, like ESPN, NHL, NBA,
MLB, CNBC, Fox News, Radio Disney
and
E! Entertainment Radio.
With SIRIUS, the emphasis is on the
music and entertainment you want.
The music is hosted by Sirius Stream
Jockeys, who are true experts. They
back up the music with compelling
information about the song being
played, and they understand that
sometimes it's best to just let the music
speak for itself.
Rely on SIRIUS rocket science for
superior coverage
Only SIRIUS has three powerful
satellites that fly directly over the US
ensuring coast-to-coast coverage with
high elevation angles. This gives the
satellites a"clear line
of sight" to your
car
or home with much less concern for
buildings, trees or other objects that
might block conventional satellite
signals.
Count on S>PLEX technology for
superior sound resolution
SIRIUS employs S>PLEX technology
(statistical multiplexing), which
optimizes the fidelity
on each channel
to give you superior digital sound. So
rock really soars, jazz really jams and
country really sings.
Once you experience over 100
streams ofdigital entertainment, you'll
neverwant to leave your car. For more
information, visit www.sirius.com.
To receive SIRIUS Satellite Radio on
this receiver
This receiver contains aSIRIUS lD for
user identification. All you have to do to
become asubscriber and enable
reception of SIRIUS Satellite Radio is
to call the SIRIUS Call Center at
(888-539-SIRI) and provide the
SIRIUS
ID and afew other details.
Verifying your SIRIUS 10
1. Press and hold the [AOJ] button
for 1second or longer to enter the
Adjust mode.
Note:
The [AOJ] button is described in the
source unit instruction manual either as
the
[T] (TITLE) button or [A-M] button.
This refers to the function ofthe button
labeled "AOJ" on the source unit panel.
(":;:'\ ADd
~ or C A-M ::> etc.
aADJ
2. Press the [<<11III] or ["->J to select the
"ESN DISP" (SIRIUS 10).
3. Press the [~II] button to display
the SIRIUS lD.
The source unit displays the first 6
digits of the
12 digit SIRIUS ID in
the display.
4. Turn the [ROTARY] knob
clockwise to change to the last 6
digits ofthe SIRIUS ID.

3. INSTALLATION AND WIRING CONNECTIONS
l' Before Installation
1. Before starting, be sure to disconnect the battery's negative "-" terminal to
prevent accidents due to short-circuits.
2. Location -Considersafety and operability when selecting aplace for installation.
Avoid the following.
•Locations where the unit will hamper
or interfere with driVing.
•Locations where the unit could injure passengers
if the car stops suddenly.
•Locations exposed to direct sunlight or hot air from the heater, etc.
•Locations where the unit may be exposed to rain or water.
3. Be sure to use the included screws and brackets. Screws other than those
supplied could damage the unit.
Case
i
I
i
I
I
I
I
~------_.
8mm max.
Case
~H_~:::ge
4. When drilling holes to mount the receiver, be sure to check beforehand that
there are no obstructions
or items on the other side that could be damaged (fuel
tank, wire harnesses or other electronic devices).
(i Accessories
CD Mounting bracket 2pieces
CD Mounting screw 4pieces (J) Canoe clip 4pieces ®CeNET cable 1piece
4

Installation Example (Installing the unit under the driver's seat)
1. Attach the mounting bracketsCD to the sides
of the SIR-CL1using the screws~ provided.
2. Select the location on the floor mat. Drill
holes in the floor mat to match the positions
of the holes in the mounting brackets CD .
3. Insert the canoe c1ips@ from the rear of the
floor mat and install the SIR-CL 1.
*There are three mounting holes on each
side of the SIR-CL 1. Select the
appropriate holes to match to the
installation location.
Connection Example and Identification of Parts
[TI CeNET input/output terminal
Connect to the main unit or CD/MD changer
using the CeNET cable as specified@.
~ RCA pin terminals
These are used to output audio when the
DSC920S (sold separately) is used to operate
the receiver.
[II ANTENNA terminal
Connect to the SIRIUS antenna (sold
separately)
~ COMMANDER Controller terminal
Connection for DSC920S (sold separately)
lID COMMANDER Power Supply terminal
Used only when operating the SIR-CL1with the
DSC920S (sold separately)
I]] CeNET/STANDALONE switch
This switch is used to select the operating type:
CeNET (headunit) or STAND ALONE
(DSC920S)
cable. ';
8, SIRIUS
ULantenna cable
SIRIUS~
SIR-CL1
CLARION COMPATIBLE
SlRIUSSATEU.ITERAOlORECIEVER
Bottom view of the unit
~
~~

How to Connect
1. CeNET Cable
Orient the CeNET cable in the direction
shown in the figure and insert it until it is
locked in position. To remove the
CeNET cable, pull it by lightly grasping
the slide cap ® in your fingers.
2. SIRIUS antenna
*Make sure power is "Off'.
Connect aSIRIUS antenna (sold
separately) to the SIRIUS antenna
terminal and press until locking tab
engages.
To disconnect, make sure power is "Off',
then press the rear of the locking tab ®
to release.
6

4. SYSTEM EXAMPLES
I Example 1
SIRIUSi!
SIR-CL1
CD Main unit compatible with GeNET
connection
~ GO changer compatible with GeNET
connection
®GeNET cable (provided with the
SIR-GL1)
Using this cable, connect the
7
SIR-GL1to the main unit.
@) GeNET cable (provided with the GO
changer)
~ SIRIUS antenna (sold separately)
@Front speakers
(J) Rear speakers

IExample 2
®
SIRlusii
SIR-CL1
CD SIRIUS controller (DSC920S, sold
separately)
~ Connection cable (provided with the
DSC920S)
® Audio systems with auxiliary or
line-in connections
®
®RCA pin (audio) cable (sold
separately)
~ SIRIUS antenna (sold separately)
®Front speakers

5. CONTROLS
Source unit buttons, example 1
[ROTARY]
[< ..... ], --:----:-:...e.-~~
[~>]
Source unit buttons, example 2
[ROTARY]
[< ..... ],-~~~~~
[~>]
Notes:
•The illustrations show examples oftwo headunits with button functions.
•Since this manual covers several models, the names
of some buttons vary by
model.
As shown below, this manual gives different button names when more than
one name
is used.
[FNC] (FUNC) button,
[SCl (SCN) button etc.
9