Skiva PowerVault A5000 User manual

User Manual
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
AP115
Document Revision No.: 1.0

The Skiva PowerVault A5000 is a portable power bank that is designed
to provide extra power to your mobiles. With built-in micro-USB and
Apple certied 8-pin lightning cables, it can charge two devices
simultaneously. Fashionable LEDs show the power level anytime.
PowerVault A5000 makes a smart addition to your travel electronics
and could be your best charging assistant.
www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
2
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
Overview:
Product Features:
• Integrated micro-USB and Apple certied 8-pin lightning cables.
• Fast charging of iPhone/iPod and other micro-USB based devices.
• 5000mAh battery capacity (almost 3 times of iPhone battery)
• Charges Android smartphones with micro-USB port.
• Compact and lightweight at 4.60 oz.
• Li-ion battery that can retain charge for months.
• Charges two devices simultaneously.

Getting started:
1) Connect the PowerVault A5000 to your laptop with a micro-USB
cable (see Figure 1). When connected properly, the rst indicator
light will illuminate.
2) Keep the PowerVault A5000 connected until fully charged.
When charging is complete, all four indicator lights will
illuminate.
3) Disconnect the PowerVault A5000 from the charger after the
battery is fully charged. Leaving the device connected after the
battery is fully charged might reduce the battery’s capacity in
future charges.
www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
3
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
Safety Information:
It is important that you read the following safety information prior to
using your Skiva PowerVault A5000.
• To charge your PowerVault A5000, use the manufacturer’s 5V/1A
charger. Using alternate chargers may damage the device.
• Do not attempt to charge the PowerVault A5000 with a defective
charger.
• Keep the PowerVault A5000 away from re or extreme heat.
• Allow air ow to the PowerVault A5000 when charging.

www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
4
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
Recharge your devices:
1) Connect your PowerVault A5000 to your device using lightning
cable or micro-USB cable. To charge two devices simultaneously
(if required), kindly connect two devices with PowerVault. When
connected properly, your device starts charging automatically.
2) If charging does not begin automatically, press and hold the power
button for 1 second to turn it ON (same way to turn it OFF). LED
indicator comes on when power button was pressed and it turns
o automatically within 5 seconds to save power.
3) To avoid over-charging, PowerVault turns OFF automatically when
your devices have been fully charged. Hence charging your devices
with PowerVault is always safe and easy.
To check remaining Power Level:
Gently press power switch to turn ON power indicator, each light
accounts for 25% power as shown below:

www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
5
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
Cables disassembling:
Please pull out the lightning/micro-USB cables using your ngernail.

www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
6
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
Specications:
Product name Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
Model AP115
Battery Capacity 3.7V/5000mAh/Li-ion
Input 5V / 1A
Output 5V/2A (5V/1A & 5V/1A)
Dimension 83*50*21(mm)
Weight 4.6 oz
Troubleshooting:
Issue Resolution
Power indicators don’t light ON
while charging the PowerVault.
Ensure the charger and cable is
connected correctly through the
micro-USB port.
PowerVault doesn’t charge the
devices connected to it.
Ensure the device is connected
correctly through the built-in
lightning/micro-USB cable.
The power indicator doesn’t light
even after clicking the power
button.
PowerVault has probably run out
of power. Please charge it.
It takes too long to fully charge
PowerVault.
Need to use recognized 5V/1A
charger cable with the provided
cable to charge PowerVault.

www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
7
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
For support please contact us
at [e-mail]
Care and maintenance:
• Keep the PowerVault dry. If the PowerVault does get wet, dry it
completely before using.
• Do not use the PowerVault in wet or dusty conditions.
• Do not store the PowerVault in wet or dusty conditions.
• Do not store the PowerVault in extreme hot or cold conditions.
• Do not drop, knock or shake the PowerVault.
• Do not use harsh chemicals, cleaning solvents, or strong detergents
to clean the PowerVault.
• Do not decorate the PowerVault.
• If the PowerVault does not appear to be functioning correctly,
please contact the support team.

www.skivatech.com
Skiva PowerVault A5000 P4 Rapid
Charging Portable Battery Pack
(c) 2014 Skiva Technologies, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.