SMART-AVI HDX-Pro User manual

Use a single CAT5 to broadcast high
resolution HDTV Video, Stereo Audio,
RS232 and IR up to 1000ft away.
HDX-PRO
www.smartavi.com
User Manual
2840 N. Naomi Ave.
Burbank, California 91504
Phone: [phone]
Facsimile: [phone]
Technical Specifications
niP niP niP niP niP
.oN .oN .oN .oN .oN emaN emaN emaN emaN emaN noitpircseD noitpircseD noitpircseD noitpircseD noitpircseD
2 Dx eR laM9BDnoataDevieceR
3 Dx eT laM9BDnoataDtimsnarT
5 DNGS dnuorG
niP niP niP niP niP
.oN .oN .oN .oN .oN emaN emaN emaN emaN emaN noitpircseD noitpircseD noitpircseD noitpircseD noitpircseD
2 Dx eT lameF9BDnoataDtimsnarT
3 Dx eR lameF9BDnoataDeveiceR
5 DNGS dnuorG
Recieve on DB9 Male
Transmit on DB9 Female
© Copyright 2007 Smart-AVI, All Rights Reserved
Notice
The information contained in this document is
subject to change without notice. Smart-AVI makes
no warranty of any kind with regard to this material,
including but not limited to, implied warranties of
merchantability and fitness for any particular
purpose.
Smart-AVI will not be liable for errors contained
herein or for incidental or consequential damages in
connection with the furnishing, performance or use
of this material.
No part of this document may be photocopied,
reproduced or translated into another language with
out prior written consent from Smart-AVI.
For the complete manual, visit www.smartavi.com.
m_hdxpro-062509
TRANSMITTER AND RECEIVER
Video
Bandwidth 400MHz
Analog signal Level 1 volt
Impedance 75 ohms
Connector
3 RCA
Format
YPbPr analog component video
Audio
Bandwidth 20 KHz
Signal level OdB
Impedance 10K ohms
Connector RCA Left and Right
System and Cable
Type Cat5 UTP EIA 568A
Connector RJ45
Power
Requirements 5V DC @500mA
Connector 5x2.1 DC Jack
RS232
DB9 Male/Female
baudrate up to 115,000bps
IR
IR Emitter Output
IR Frequency Range 30KHz to 80KHz
Emitter Distance Up to 10’
Connector 3.5mm stereo jack for emitter

Introduction
The HDX-PRO range of products allows the extension
of a wide range of video and audio formats, RS232,
and IR via a single Category 5 Unshielded Twisted
Pair (UTP) cable.
Features
Supports HDTV Screen
Y,Pb, Pr
Uses easy to install, inexpensive CAT-5/5e/6/7/8.
Output reaches up to 1,000 feet (300 m).
Resolutions up to 1900x1200.
300 MHz Bandwidth.
Sends high-resolution HDTV component, Stereo
Audio, RS232 and IR
Compatible with Line Level Stereo Audio Signals.
High ground loop immunity.
Built-in lightning, power surge and transient
protection.
Designated trimmer in the remote unit to
compensate for cable length.
Compact Metal Case Enclosure.
Supports RS232 and IR
What’s in the box?
HDX-PRO
Please check the contents of the package before
beginning installation.
Installation Diagram
Adjusting and Tuning the SignalAdjusting and Tuning the Signal
Adjusting and Tuning the SignalAdjusting and Tuning the Signal
Adjusting and Tuning the Signal
In order to fine tune the signal, adjust the individual
dials one at a time starting with GREEN, then BLUE,
and lastly RED. As you turn the dials you will notice
the colors slightly change as you increase or decrease
the strength. All dials should be around the same
distance.
Preparing & Connecting System CAT5 CablePreparing & Connecting System CAT5 Cable
Preparing & Connecting System CAT5 CablePreparing & Connecting System CAT5 Cable
Preparing & Connecting System CAT5 Cable
Following is the wiring standard for terminating CAT 5 cable
using RJ-45 connector:
Pair 1 Pins 1 & 2
Pair 2 Pins 3 & 6
Pair 3 Pins 4 & 5
Pair 4 Pins 7 & 8
Connectors:Connectors:
Connectors:Connectors:
Connectors:RJ-45
Capacitance:Capacitance:
Capacitance:Capacitance:
Capacitance:14 pf/ft (46.2 pf/m)
Conductor Gauge:ConductorGauge:
Conductor Gauge:Conductor Gauge:
Conductor Gauge: 24 AWG
tnetnoCegakcaP tnetnoCegakcaP tnetnoCegakcaP tnetnoCegakcaP tnetnoCegakcaPHDX-PROX
ytQ ytQ ytQ ytQ yt sQ metI smetI smetI smetI smet .I oNtraP .oNtraP .oNtraP .oNtraP .oNtraP
y2 lppusrewopcdtlov S5 U-A1D5-SP
)1 tf6(elbacAGVelamotelam51DD 6H 0-MMAGV-CC
lanoitpO lanoitpO lanoitpO lanoitpO lanoitpO
e1 lbacgulpinimoeretsmm5.3oidu 6A 0MMDA-CC
1 revieceREYER EI YE-MS
1 rettimER DI EL-MS
.1 tf69BDf/mlaire 6S 0FMRESCC
1 HDX-PRO Transmitter Unit HDX-PRO-TX
1 HDX-PRO Receiver Unit HDX-PRO-RX
Connecting The Transmitter
1. Connect the output of component video source to the
video input of the transmitter using RCA to RCA cable
2. Connect audio source to
the audio input of the transmitter using audio rca cable
5. In the back of the unit connect the CAT5 cable that
will connect to the receiver (XTPRO-RX).
*NOTE: You can not use RS232 and IR at the same time.
Connecting The Receiver
1. Connect CAT5 cable (coming from the transmitter) to
the back of the receiver.
2. Connect display monitors to the RCA
connectors on the front of the receiver.
3. Connect a sets of external speakers to the audio
output connections on the front of the unit.
DVD Player
IR
IR
HDX-PRO Transmitter Unit
HDX-PRO Reciever Unit
Remote Monitor
Cat 5
Audio
Video
Audio
Video
Speakers