
The EOLIS sensor RTS is a radio sensor for awnings with a protection against
wind damage.
The wind threshold can be set directly on the EOLIS sensor RTS.
The EOLIS sensor RTS has to be used with the OREA RTS and ALTUS RTS
motors.
®
Mains supply : 220-240 V~ 50/60 Hz
Protection index : IP34 (cable bushing not drilled. Only guaranted if professionally installed).
Operating temperature : -20°C to +50°C
Class II product once installed
inteo EOLIS sensor RTS
INSTALLATIONguide
Ref.9000839B
Installation:
1
;
;
;
;
;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;
;
;
;
;
;
;
;
;
;
;;;;
;;;;
;;;;
;;;;
;;;;
;;;;
;;;;
Press more than 2 seconds
on the programming button of
a RTS control which is already
memorized in the motor.
(please refer to the installation guide of
the concerned motor).
Press briefly on the
“prog” button of the
EOLIS sensor RTS.
➜
236 mm
160 mm
Connect the cable
to the terminal.
Put the
cover
Fix the sensor
to the wall.
Put and screw
the front box.
MAINS
230V - 50Hz
2 wires x 0,75 mm2
Neutral
Phase
The motor must be in its learning mode to record an EOLIS sensor RTS.
Up to three EOLIS sensors RTS can be memorized in a motor and one EOLIS sensor RTS can be memorized in several motors.
Programming:
2
Characteristics
Mounting Cabling
The awning moves shortly
(DOWN/UP).
the motor is in “learning” mode.
Enter the “learning” mode Record or delete a sensor
The awning moves shortly (DOWN/UP).
If it is a new sensor : it will be recorded in the motor.
If the sensor was already recorded : it will be erased.
Press more than 7 sec. on
the “prog”button of the
new EOLIS sensor RTS.
Erase all the sensors and record a new one
The awning moves shortly (DOWN/UP).
the memory of the receiver is cleared (all the
previous sensors are erased) and the new
sensor is recorded.
0165
Hereby, SOMFY, declares that this equipment is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web address www.somfy.com Heading CE