Sonnen sonnenBatterie eco 8.2 Manual

Sonnen eco 8.2
Z-Wave Control

216.06.2017 sonnen Australia Pty Ltd
sonnen eco 8
Z-Wave Control
The Z-Wave USB is supplied within the
accessory kit of the main unit:
»Insert the Z-Wave USB into the
dedicated port of the PLC mounted on
the rear of the main cabinet door.
Technical specifications:
»Max standby power: 0.5W.
»USB output: DC 5V±0.3V, 1000mA.
»Operating temperature: 0 C to 40 C .
»Relative humidity: 8% to 80%.
»Operating distance: Up to 100 feet/30
metres indoors or300 feet/100 metres
outdoors.
»AC Input: 230V50Hz Max 10A
»Operating Frequency: 921.42MHz

316.06.2017 sonnen Australia Pty Ltd
The Smart Switch 6 is a low-cost Z-Wave plug-in module specifically used to enable Z-Wave command
and control (on/off) of any plug-in tool. It can report immediate wattage consumption or kWh energy
usage over a period of time. In the event of power failure, non-volatile memory retains all
programmed information relating to the unit’s operating status.
Its surface has Smart RGB LED, which can be used for indicating the output load status or strength of
the wireless signal. You can configure its indication colour according you your preferenced.
Smart Switch 6 is also a security Z-wave device and supports Over The Air (OTA) feature for the
products firmware upgrade.
sonnen eco 8.2
Z-Wave Control

416.06.2017 sonnen Australia Pty Ltd
sonnen eco 8.2
Z-Wave Control
Once the USB has been inserted into the PLC, plug a Z-Wave Smart
Switch 6 Socket into a wall outlet within 3 meters from the sonnen
eco8.2 unit.
Via the Smartphone App select the ‘Smart-Plugs’ setting to
proceed.

516.06.2017 sonnen Australia Pty Ltd
sonnen eco 8.2
Z-Wave Control