Sony Ericsson HCB-30 User manual

Notfor CommercialUse
1
Contents
English.............................................3
Deutsch .........................................17
Español .........................................33
Français.........................................49
Italiano...........................................65
......................................81
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
!"#$

Notfor CommercialUse

Notfor CommercialUse
3
English
Introduction 4
Preparing the car handsfree 5
Using the car handsfree 8
Troubleshooting 12
Additional information 14
Declaration of conformity 93
Sony Ericsson HCB-30
First edition (June 2002)
This manual is published by Sony Ericsson Mobile
Communications AB, without any warranty. Improvements and
changes to this manual necessitated by typographical errors,
inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Sony Ericsson Mobile
Communications AB at any time and without notice. Such changes
will, however, be incorporated into new editions of this manual.
All rights reserved.
©Sony Ericsson Mobile Communications AB, 2002
Publication number: LZT 108 5844/1 R1A
Some of the services in this manual are not supported by all
networks. This also applies to the GSM International Emergency
Number 112.
Contact your network operator or service provider if you are in
doubt whether you can use a particular service or not.
The Bluetooth trademarks are owned by Bluetooth SIG, Inc. USA.

Notfor CommercialUse
4 Introduction
Introduction
The Bluetooth™ Car Handsfree
HCB-30 is based on Bluetooth
wireless technology.
See “Safe and efficient use” on page 14 and
“Limited Warranty” on page 15 before using your car
handsfree.
What is Bluetooth wireless technology?
The Bluetooth wireless technology makes it possible
to connect any compatible portable and stationary
communications device within a range of 10 m (30 ft)
without using cables. The technology is based on
a radio link that offers fast and reliable transmission
of voice and data information. It does not require
a line-of-sight connection in order to establish
communication. Bluetooth wireless technology uses
a globally available frequency range intended to
ensure communication compatibility worldwide.
How can I use my car handsfree?
When you turn the ignition key of your car, the
Bluetooth car handsfree is switched on automatically.
The phone can be left in your coat pocket or bag while
you make and answer calls via the Bluetooth car
handsfree control panel. The car stereo is muted when
you receive a call, and you hear the caller in a separate
loudspeaker.
What products can I use with my car handsfree?
With the Bluetooth Car Handsfree HCB-30, you can
use a Sony Ericsson or Ericsson phone with built-in
Bluetooth capability, or with a Bluetooth phone
adapter. You can use products that support the
Bluetooth Headset profile or the Bluetooth Handsfree
profile.
To enhance your experience of the Bluetooth Car
Handsfree HCB-30, we recommend that you also buy
an advanced music mute and a gooseneck microphone.
• Advanced Music Mute HCE-16 – for enhanced sound
experience in the car. You hear the caller in the car
stereo loudspeakers instead of in the separate
loudspeaker.

Notfor CommercialUse
Preparing the car handsfree 5
• Gooseneck Microphone HCE-14 – for enhanced sound
experience for the person you are talking to.
You can, for example, also use the following
accessories with your phone and Bluetooth Car
Handsfree HCB-30:
• Cigarette Lighter Adapter CLA-11 – for charging of
the phone in the car.
• Antenna Cable Connector HCE-12 – together with
a car holder for better network reception.
• Car Holder, for example, HCH-28 – together with an
antenna cable connector for better network reception.
Preparing the car handsfree
To be able to use the car handsfree together with
a mobile phone, you need to have a phone with built-in
Bluetooth capability, or a phone with a Bluetooth
adapter connected to it.
You use the keys of the control panel to handle calls.
Control panel overview
End and reject calls
Volume up
Volume down
Indicator lights
Turn off/on the
microphone
Make and
answer calls

Notfor CommercialUse
6 Preparing the car handsfree
Indicator lights
Instructions
Instructions in this User’s Guide are based on car
handsfree keys and phone keys. For example, the
key or the YES key on the phone can be used to answer
a call.
Getting Started
Before you start using the car handsfree with a phone
for the first time, you need to:
• Have the car handsfree kit installed in the car.
Please refer to the Installation Guide.
Note: Please note that the car handsfree should be
installed by authorised personnel. Check with your
car dealer for recommendations on professional
installation engineers.
• Pair the car handsfree with your mobile phone. See
“Pairing the car handsfree” on page 7.
To turn the car handsfree on
• Turn the ignition key to on, or press and hold
until you hear a short low tone followed by a short high
tone. The backlight of the control panel is blue. The car
handsfree is on.
Note: The first time the car handsfree is turned on, and
whenever no devices are paired with the car handsfree,
it will automatically be ready for pairing.
The indicator light...
is green Network coverage and
ongoing Bluetooth
connection.
is red No network coverage and
ongoing Bluetooth
connection.
flashes green slowly Ongoing call.
flashes green and red Pairing mode.
flashes red Creating a Bluetooth
connection.
is off No ongoing Bluetooth
connection.

Notfor CommercialUse
Preparing the car handsfree 7
To turn the car handsfree off
• Turn the ignition key to off.
The car handsfree is automatically turned off one hour
after the ignition is turned off. This way, an ongoing
call is not interrupted when the ignition is turned off.
The backlight of the control panel switches off. The car
handsfree is off.
• You can also turn the car handsfree off by pressing and
holding until you hear a short high tone followed
by a short low tone.
Pairing the car handsfree
Before you can use your car handsfree, you must pair it
with your mobile phone. You pair the car handsfree
with the phone by adding the car handsfree to a list of
paired devices in the phone. They then recognize each
other when they connect.
To pair the car handsfree with a Sony Ericsson or
Ericsson phone
1. Turn on the car handsfree.
2. If the indicator light is green or red, the car handsfree
is connected to a Bluetooth device. To disconnect
the devices, press until you hear a tone.
The indicator light is turned off.
3. Press and hold and at the same time until
you hear a long high tone and the indicator lights on
the control panel flash green and red.
4. In the phone, scroll to Extras or Connect, YES,
Bluetooth, YES, Paired devices, YES, Add device, YES,
Phone initiates, YES.
5. A list of device types that you can pair with your phone
appears. Scroll to Headset or Handsfree and press YES.
6. HCB-30 appears in the display. Press YES.
7. Enter the car handsfree passkey (0000) and press YES.
The phone pairing procedure starts.
8. You may now replace the given car handsfree name
with a name of your choice and then press YES.
When pairing has been completed, the indicator light
on top of the control panel stops flashing.
To pair the car handsfree (general instructions)
1. Turn on the car handsfree.
2. Prepare your phone according to the phone’s user
documentation on pairing.
3. If the indicator light is green or red, the car handsfree
is connected to a Bluetooth device. To disconnect
the devices, press until you hear a tone.
The indicator light is turned off.

Notfor CommercialUse
8 Using the car handsfree
4. Press and hold and at the same time until
you hear a long high tone and the indicator lights on
the control panel flash green and red.
5. Continue according to the instructions in the phone’s
user documentation. The car handsfree passkey
is 0000.
Resetting the car handsfree
You may want to reset the car handsfree to its default
settings. This also clears all current pairings.
To reset the car handsfree
1. Turn on the car handsfree.
2. If the indicator light is green or red, the car handsfree
is connected to a Bluetooth device. To disconnect
the devices, press until you hear a tone.
The indicator light is turned off.
3. Press and at the same time until you hear
a long high tone.
4. Press and at the same time until you hear
a long low tone.
The car handsfree has now been reset and all current
pairings in your car handsfree have been cleared.
Using the car handsfree
Once you have paired the car handsfree with your
phone, you can make and receive calls using the
control panel of the car handsfree, as long as it is
turned on and within range of the phone, with no solid
objects in between.
The following instructions cover the use of the car
handsfree with a Sony Ericsson or Ericsson phone with
built-in Bluetooth capability, or with a Bluetooth phone
adapter from Sony Ericsson or Ericsson. If you have
another make of mobile phone, please refer to the
phone’s user documentation.
Note: Always make sure the Bluetooth operation mode
in the phone is on when using a Bluetooth car handsfree.
Making calls
Phone functionality is still available when the car
handsfree is connected. You can make a call using
the phone keys or using the control panel of the car
handsfree. To make a call using the control panel,
you use the voice dialling function.

Notfor CommercialUse
Using the car handsfree 9
Note: Before voice dialling, you must turn on the voice
dialling function and record voice commands in your
phone. Please refer to the phone’s user documentation.
To make a call using voice dialling
1. Make sure the phone and the car handsfree are on and
within range of each other. Press and hold . You
hear a tone.
2. After the highest tone (second or third tone), voice dial
as you normally would.
3. End the call by pressing . For some phones,
press .
You can also make a call using the phone’s keypad
or phone book (if, for example, your phone does not
support voice dialling).
Note: The number of tones that you hear when voice
dialling is dependent on the type of phone. With some
phones, you may only hear one tone. Say your voice
command after the tone.
Answering calls
When you receive a call, the car stereo is muted
automatically. You can answer the call using ,
using voice answer commands, or using automatic
answering mode.
Note: For information about voice answering and
automatic answering mode, please refer to the phone’s
user documentation.
To answer a call
• When the car handsfree rings, press .
To end a call
• Press .
Note: For some phones, press .
To reject a call
• When the car handsfree rings, press .
Note: This is dependent on the type of phone.

Notfor CommercialUse
10 Using the car handsfree
To turn off the microphone
• During a call, press to turn off the microphone.
You hear a tone when the microphone has been turned
off.
• Press again to resume the conversation.
Adjusting the speaker volume
You can adjust the car handsfree speaker volume
during a call. You hear a tone when you reach the
maximum and minimum volume levels.
To adjust the speaker volume
• To increase the volume, press during a call.
• To decrease the volume, press during a call.
Adjusting the ring volume
You can adjust the car handsfree ring volume when
you are not engaged in a call.
To adjust the ring volume
• To increase the ring volume, press .
• To decrease the ring volume, press .
Transferring sound to car handsfree
If you make a call without using the car handsfree,
you can, with some phones, transfer the sound from
the phone to the car handsfree if the car handsfree is
on, paired with the phone and within range.
To transfer the sound to the car handsfree
• During a call, press on the car handsfree until you
hear a tone. (This is dependent on the type of phone.)
• Or, in some phones, scroll to Ongoing call, YES,
Transfer sound, YES. Select the car handsfree in the list,
YES. You hear a short high tone when the sound has
been transferred.
Transferring sound to phone
If you make a call using the car handsfree, but for some
reason want to take the call in your mobile phone instead,
you can transfer the sound from the car handsfree to
the phone.