Soozier A91-120 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
INadd039_US
A91-120

BOX-1/2 BOX-2/2
NO. PARTS QTY NO. PARTS QTY
PACKING DETALS:TOTAL 2 BOXES
Hardware Kit
F1A2
1
B
C1
1
D
E1
1
H

PART
LIST
Fill the base(F) with water or sand replacethe cap
01
H 1
G12
F 1
E 1
D 1
C 1
B 1
A 2
N 1
L 1
K 2
J 1
I15

Done
02
Boxing is a contact sport.Any contact can be dangerous and result in serious
injury. When boxing, be sure you are in good physicai condition and under expert
supervision.This eqquipment will provide limited protection but will not protect
you against serious injury. Anyone using this equipment must assume the risk of
any injury.
1.Install the suction cup (G) on the bottom of the base (F)
2.Fix the connector (E )on base(F) with the wrench (J)and the Screw(I)
3.Insert the upper secttion (C) into the Percussion body (D) and set to the desired
height.use the butterffly screw to fix the upper section into place.
4.Install the rotating rod (B) on the upper end ofthe adjusting rod (C) ,Install the
pipe fitting(N) onto the main rod (C)and fix it
5.Put the washer on top of adjusting rod (C) and install the spring (K)
6.Pump up the punch ball by using the pump(H) proided ,then screw into position
at the top of the Spring(K)
7.Only use a safe place, well aways from all obstacles, breakaable items or other
hazards.
A
B
C
D
E
F
G
H
I
J
L
N
K
A
K