Sota Magnetic Pulser MP6 Operating instructions

Page 1 of 2
Troubleshooting
MP6
GREEN Power Light
Is Not On.
Ensure Wall
Adaptor is fully
plugged into the unit
and the wall outlet.
Try another wall
outlet.
Try a different Wall
Adaptor -
12 Volts DC with a
Center Positive Pin
that supplies
at least 1.5 Amps.
No GREEN/YELLOW
Charging Lights.
Is the first GREEN Power
light on? Yes
No
GREEN/YELLOW Charging
Lights come on, but
no RED Light.
Ensure the
correct Wall Adaptor is being
used - 12 Volts DC with
a Center Positive Pin that
supplies at least
1.5 Amps.
Try a different Wall
Adaptor -
12 Volts DC with a
Center Positive Pin
that supplies
at least 1.5 Amps.
There may be a fault with the
unit. Contact Customer Care at
1.800.224.0242
or [email protected]
There may be a fault with the
unit. Contact Customer Care at
1.800.224.0242
or [email protected]
There may be a fault with the
unit. Contact Customer Care at
1.800.224.0242
or [email protected]

Page 2 of 2
Troubleshooting
MP6
Hand Paddle heats up
after one or two cycles.
This is normal. The
Hand Paddle contains a
coil through which the
magnetic field is released
causing the coil to
generate heat.
If the heat from the
paddle is uncomfortable
we suggest:
Put a cloth around
the paddle - a sock
works well.
Turn the unit off
and allow the paddle
to cool before
continuing.
Unit is beeping and the
RED and GREEN/YELLOW
Lights are flashing rapidly.
There is a fault with the
unit. Contact Customer Care at
1.800.224.0242
or [email protected]
Pulse Takes Too Long To
Build and Release
Ensure the
correct Wall Adaptor is being
used - 12 Volts DC with
a Center Positive Pin that
supplies at least
1.5 Amps.
Try a different Wall
Adaptor -
12 Volts DC with a
Center Positive Pin
that supplies
at least 1.5 Amps.
There may be a fault with the
unit. Contact Customer Care at
1.800.224.0242
or [email protected]