Spa Electrics ARGON User manual

INSERT FLAT BLADE SCREWDRIVER
INTO NICHE ABOVE TOP 12 O’CLOCK ARROW
AND LEVER OFF LIGHT RIM
ROTATE LIGHT ASSEMBLY COUNTER-CLOCKWISE
SO THE ARROW ON THE LIGHT ASSEMBLY IS AT
10 O’CLOCK AND THEN PULL OUT THE LIGHT
ASSEMBLY FROM NICHE
LIGHT REMOVAL
PRODUCT SUPPORT & INFORMATION
For the most up to date installation information and contact information
for assistance in your region, please visit www.spaelectrics.com
COPYRIGHT 2020 SPA ELECTRICS PTY. LTD. ALL RIGHTS RESERVED US 20201116
www.spaelectrics.com
Toll Free: 1800 708 5545
Email: [e-mail]
WINTERIZATION
INSTRUCTIONS
1: PUSH AND LEVER OFF LIGHT RIM
WITH FLAT BLADE
2: ROTATE AND PULL OUT LIGHT ASSEMBLY
STORAGE
ENSURE LIGHT ASSEMBLY AND LIGHT RIM
IS SAFELY STORED FOR NEXT SEASON USE
UNSCREW PLUG COLLAR
COUNTER-CLOCKWISE
UNTIL IT IS
FREE SPINNING
DISCONNECT LIGHT
ASSEMBLY FROM PLUG
BY PULLING APART
3: REMOVE PLUG
FROM LIGHT
4: DISCONNECT THE
TERMINALS
• Flat-blade screw driver
• Lights must be removed from pool wall and cable disconnected via plug connection & stored in a safe place.
• Winterization Cover must be fitted to Plug Top prior to reinstalling into niche for winter.
• Unless niche/conduit connection is adequately sealed (i.e. via included cable gland components),
pool water level must be drained down 12” below the lowest light(s) position in pool wall.
• All conduits should be checked for accumulated water and drained if required.
• Follow instructions OR consult your local pool professional for complete pool winterization process.
• All installation steps should be carried out with manual tools only. The use of power tools during installation is not
recommended as these devices can cause faults and damage to light components.
• Images are for illustrative purposes only. Appearances of parts and assemblies may vary from the illustrations.
TOOLS REQUIRED
IMPORTANT NOTES

PRODUCT SUPPORT & INFORMATION
For the most up to date installation information and contact information
for assistance in your region, please visit www.spaelectrics.com
COPYRIGHT 2020 SPA ELECTRICS PTY. LTD. ALL RIGHTS RESERVED US 20201116
www.spaelectrics.com
Toll Free: 1800 708 5545
Email: [e-mail]
WINTERIZATION
INSTRUCTIONS
WINTERIZATION COVER ATTACHMENT
PLACE WINTERIZATION COVER ONTO CLAMP RING
AT 10 O’CLOCK AND TURN CLOCKWISE TO 12 O’CLOCK
TO LOCK INTO PLACE
ALIGN TERMINAL PINS ON PLUG
WITH TERMINAL PINS ON BACK
OF WINTERIZATION COVER AND
FIRMLY ASSEMBLE PLUG TO COVER
1: CONNECT WINTERIZATION COVER TO PLUG
2: COIL CABLE BACK INTO NICHE
3: LOCK ON WINTERIZATION COVER
TO LOCK INTO PLACE:
TWIST COLLAR CLOCKWISE
A FEW TIMES UNTIL
IT’S HAND TIGHT
IMPORTANT
ENSURE THE COLLAR
MARKER STOPS AT OR
PAST THE ALIGNMENT
MARKER ON THE
LIGHT HOUSING