Specac Golden Gate User manual

Golden Gate™ Heated
Diamond ATR Top-Plate
User Manual
2I-10540 Issue 14

Golden Gate™ Heated
Diamond ATR Top-Plate
User Manual
2I-10540 Issue 14

User Manual
2
Golden Gate Heated Diamond ATR Top-Plate
CONTENTS
1. INTRODUCTION .................................................................................3
2. UNPACKING AND CHECKLIST .............................................................4
3. DISPLAYABLE PARAMETERS AND SPECIFICATIONS .............................5
© April 2016 Specac Ltd. All rights reserved.
Golden Gate and Brilliant Spectroscopy are trademarks of Specac Ltd.
Other product names mentioned herein may be trademarks of their
respective owners.

Heated Golden Gate™
3
1. Introduction
The Golden Gate™ Heated Diamond ATR Top Plate (P/N’s GS10540
and GS10542) is one of a series of top plates that are used on the
optical unit of the Golden Gate™ATR system.
The Heated Diamond ATR Top Plate is operable from ambient to
200°C temperature by a dedicated 4000 Series™ Temperature
Controller.
This particular manual is to be used in conjunction with the standard
Golden Gate™manual (GS10500 Series) supplied with every Golden
Gate™system and a separate 4000 Series™ Temperature Controller
manual.
Warning: The diamond mounting in the Gold Gate™ ATR Top
Plate has a very small air gap around its periphery.
This is to minimize heat loss to the surrounding top-
plate and to ensure quick warm up. It is possible, when
cleaning the diamond with excessive amounts of
solvent, for some of this to leak past the diamond plate
and give solvent absorption bands. For this reason, the
diamond should only be cleaned with tissue moistened
with solvent.
Before powering up the controller make sure that the
power/ thermocouple lead of the Heated Golden
Gate™ATR Top-plate is connected to the back of the
4000 Series™ Temperature Controller. The plug is a
push fit and the knurled ring is rotated to click the plug
into position.

User Manual
4
2. Unpacking and Checklist
On receipt of the equipment please check that the following have been
supplied:
•Golden Gate™Heated Diamond ATR Top-plate (GS10540)
•Golden Gate™Optical unit with choice of ZnSe or KRS-5 lenses
and appropriate Benchmark baseplate (if ordered as GS10542).
•4000 Series™ Temperature Controller, Power Cable and Manual
Remove the top plate and/or Golden Gate™optics unit from their
packing and install the Golden Gate™ ATR unit and the top plate into
the spectrometer (see Golden Gate™Manual GS10500).
For heating of the Golden Gate™Heated Diamond ATR Top-Plate
please follow instructions from the 4000 Series™ Temperature
Controller Manual.

Heated Golden Gate™
5
3. Displayable Parameters and Specifications
The Golden Gate™Heated Diamond ATR Top Plate is provided with
its own dedicated 4000 Series™ Temperature Controller. A separate
manual is supplied for specific operation of the 4000 Series™
Temperature Controller.
For operation of the Heated Diamond ATR Top Plate the parameters of
the 4000 Series™ Temperature Controller have been factory set as
shown on the following page. Not all the displayable parameters can
be changed but have been listed for reference purposes. If you ever
need to change a parameter or autotune the controller for a specific
temperature range, certain parameter settings will be altered. You can
get back to original factory settings by reprogramming the controller
with these original values.
Specifications
Accessory Type GS10540 or GS10452
Voltage
230V
110V
100V
Frequency
50HZ
60HZ
50/60HZ
Max Power
150W
150W
150W
Fuse Rating
1.5A
3A
3A
Fuse Type
T
T
T
Insulation rating of external circuits (appropriate for single fault
condition) = basic insulation and protective (earth) bonding.
Humidity operation range –20% to 90% relative humidity non-
condensing.

User Manual
6
Displayable Parameters For Heated Golden Gate™GS10540 with
WEST 6100+ (4000 Series™) Controllers
Parameter
Display (In
Green)
Parameter Name
Parameter Factory
Set Value
FiLt
Input Filter Time Constant
3.0
OFFS
Process Variable Offset
0
PP
Primary (Heat) Output
Power
0
Pb_P
Primary Output
Proportional Band
3.8
ArSt
Automatic Reset (Integral
Time Constant)
0.31
rAtE
Rate (Derivative Time
Constant)
0.07
biAS
Manual Reset (Bias)
25
SPuL
Setpoint Upper Limit
200
SPLL
Setpoint Lower Limit
0
OPuL
Primary (Heat) Output
Upper Power Limit
100
Ct l
Output 1 Cycle Time
4
PhAl
Process High Alarm
200
AHyl
Alarm 1 Hysteresis
1
PLA2
Process Low Alarm
0
AHy2
Alarm 2 Hysteresis
2
APt
Auto Pre-Tune
enable/disable
diSA
PoEn
Manual Control select
enable/disable
diSA
SPr
Setpoint Ramping
enable/disable
EnAb
rP
Setpoint Ramp Rate Value
1800
SP
SP Value
1
SLoc
Set-up Lock Code
10

Heated Golden Gate™
7

Notes

Worldwide Distribution
France
Eurolabo - Paris.
Tel.[phone]
Fax [phone]
email: [e-mail]
Germany
L.O.T. - Oriel GmbH & Co,
KG - Darmstadt
Tel: [phone]
Fax: [phone]
email:[e-mail]
Website: www.LOT-Oriel.com/de
Japan
Systems Engineering Inc. -Tokyo
Tel: [phone]
Fax: [phone]
email:[e-mail]
Website: www.systems-eng.co.jp
Spain
Teknokroma S.Coop C. Ltda
Barcelona
Tel: [phone]
Fax: [phone]
email: [e-mail]
Switzerland
Portmann InstrumentsAG
Biel-Benken
Tel: [phone]
Fax: [phone]
email: [e-mail]
Website:www.portmann-instruments.ch
USA
SPECAC INC.
414 Commerce Drive
Suite 175,
Fort Washington,
PA 19034, USA
Tel: [phone]
Fax: [phone]
United Kingdom
Specac Ltd. - London
Unit 12, Science & Innovation Centre
Halo Business Park
Orpington
Kent BR5 3FQ
Tel:[phone]
Registered No. 1008689 England

Brilliant Spectroscopy™
www.specac.com
SPECAC INC.
414 Commerce Drive
Suite 175,
Fort Washington,
PA 19034, USA
Tel: [phone]
Fax: [phone]
SPECAC LTD.
Unit 12, Science & Innovation Centre
Halo Business Park
Orpington
Kent BR5 3FQ
Tel: [phone]
Registered No. 1008689 England