Speco NXL User manual

NXL NVR
Quick Start Guide
Version 1.1.3

2
Welcome
Thank you for purchasing this NVR.
This guide is designed to be a quick reference for installing the system.
Please read this guide carefully before installing and operating the unit.
If technical assistance is needed, please contact Speco Technologies Technical Support.
Phone [phone] option 3
Email tech[email protected]
Important Safeguards and Warnings
Speco Technologies assumes no liability or responsibility for any fires or electrical shock caused
by improper handling or installation.
Speco Technologies is not liable for any problems caused by unauthorized modifications or
attempted repair, which will void the warranty.
Note All of the installation and operations here should conform to local
electric safety rules.
Package Contents
48VDC Power Adapter & Power Cable
CD
Mouse
Ethernet Cable
Quick Start Guide
Unit

3
1. Check Unit
After unpacking the unit, please check for any visible damage. Then check to make sure that all
accessories are included.
2. Product Label
Check that the model number and serial number that’s listed on the label on the unit are the same
as what’s listed on the package label.
3. Front Panel
The front panel is shown as in Figure 1.
Figure 1
Please refer to the following sheet for detailed information.
Icon Name Function
LAN Network status indicator
Blue indicator is on when connected to a
network
PWR Power indicator
Blue indicator
is on when power is operating
normally
HDD HDD status indicator
Blue indicator is on when the hard drive is
operating normally
4. Rear Panel
The rear panel is shown in Figure 2 (8ch unit shown).
Figure 2
Please refer to the following sheet for detailed information.
Port Name Connection Function
USB2.0 port
May be used for a mouse and external storage.

4
Port Name Connection Function
Network port
10M/100Mbps
Etherne
t port.
Connect to
a
network
cable.
HDMI HDMI v1.4
Used for video output to a monitor/display with
HDMI port
VGA VGA output
Used for video output to a monitor/display with
VGA port
GND Ground end
Power input port Input DC 12V/2A.
MIC IN Audio input port Audio input port for two-way audio. Connect a
microphone.
MIC OUT Audio output
port
Audio output port to a speaker
Two-way audio output.
Audio output on full screen live view.
Audio output on full screen playback.

5
5. Unit Login
After the system boots up, the default video display is in multi-window mode.
See Figure 3 for the login interface.
Listed below is the default login ID
Username admin (administrator, local and remote)
Note
For security purposes, it is required to create the administrator password on the initial login.
5 incorrect login attempts within 30 minutes will result in a lock on the account. Once the unit is
locked, please wait for 30 minutes before attempting to log in again.
To reset the password, please contact Speco Technologies Technical Support.
Figure 3
6. Remote Web Access
Open Internet Explorer and enter the NVR’s IP address in the address bar.
Follow the instructions to install the plug-in.
After installation, the login interface is shown as below. See Figure 4.
Please enter the user name and password.
Figure 4