Spectrum Industries 55111 User manual

Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Assembly Instructions
Tools
Required
0120372R2 Page 1 of 2
Assembly Instructions
Customized Logo Panel
for MM Series Link and Compact Lecterns
55111
(1) 0120202
Logo Panel
Drill with
1/4” drill bit
3/8” or
adjustable
wrench
Figure 1A Figure 1B
Audience-side
panel
1. Locate and ip-up the audience-side ip-up panel. Figure 1A.
2. Unlock the two panel locks.
3. Carefully lift out the audience-side panel. Figure 1B.
Installation
Slot in base panel
Audience side
panel lock access
Flip-up panel
(6) 0104260
10-32 Keps nut
(6) 026059
1/4” Flat washer

0120372R2 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Figure 1C
Logo panel
Removed
Audience-side
panel
4. Locate the (6) starter holes in the back of the audience-side panel. Figure 1C.
5. Using a 1/4” drill bit, slowly drill completely through the panel at the 6 hole locations.
6. Align the logo panel studs with the drilled holes and secure with (6) 1/4” at washers and (6) 10-32 Keps nuts. Figure 1D.
7. To re-install the audience-side panel, insert the panel tab into the slot in the base panel, then tip the panel back into
position, and re-lock the locks.
Figure 1D
Removed
Audience-side
panel
Carefully drill through
the panel with a 1/4”
drill bit at these loca-
tions (6 holes total)
Use a sharp 1/4” drill bit to drill out the (4) existing starter holes.
Drill slowly to minimize laminate chip-out around the holes.
Placing masking tape on the laminate-side of the panel at the
hole locations before drilling will also help minimize chip-out.
1/4” at washer
(6 required)
10-32 Keps nuts
(6 required)