Spectrum Industries 55416 User manual

55417
(1) 0142034
Door and frame
assembly
(4) 0100167
8-32 x 1/2”
PH thread-ctg
screws
Door and frame
assembly
Assembly Instructions
0191025 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Security Door Kit for Collectiv8™
55416 - Door Kit with top panel
55417 - Door Kit only
55416
(1) 0142034
Door and frame
assembly
1. Attach Door & Frame Assembly
1. Remove any at or L-brackets attached to the front the unit.
2. Align the door and frame assembly with the upper and lower
Collectiv8 mounting holes, then align any previously removed
Flat brackets. Figure 1.1. (If no brackets were used, the frame
assembly will just attach with the included 8-32 screws).
3. Attach the door and frame assembly to the Collectiv8 with (4) 8-32
x 1/2” PH thrd-ctg screws, and tighten securely.
4. If necessary, secure the L-brackets to the worksurface. Figure 1.2
Figure 1.2
L-Bracket
Tools
Required
Phillips
screwdriver
55417
55416
(4) 0100167
8-32 x 1/2”
PH thread-ctg
screws
(1) 0142163
Top Panel
(2) 021588
8-32 Keps nut
8-32 x 1/2”
PH Thrd ctg
Collectiv8
Figure 1.1
X 2
X 2
8-32 x 1/2”
PH Thrd ctg
Flat Bracket
Frame
Assembly
Collectiv8
Frame
Assembly
If L-brackets will be used to secure the Collectiv8 to a surface,
the L-bracket needs to be secured to the surface 1st.
Then the Collectiv8 can be placed over the L-brackets, and
secured with the 8-32 x 1/2” PH Thrd ctg screws.

0191025 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2018 Spectrum Industries Inc., All rights reserved.
2. Attach Top Panel (55416 only)
1. Open doors.
2. Remove the (2) existing #8 x 3/8” PHSM screws from the top of the unit.
3. Align the top panel with the Collectiv8 mounting holes. Figure 2.
4. Attach with (2) 8-32 Keps nuts, and (2) previously removed #8 x 3/8”
PHSM screws.
Note: The top panel only gets installed at the top of a Collectiv8 unit or stack.
Figure 2
Tools
Required
Phillips
screwdriver
11/32” or Adjustable
wrench
(2) existing
#8 x 3/8” PHSM
(2) 8-32 Keps nut
Top Panel