Sperian professional Optrel Galaxy Flip-Up AUS User manual

Optrel GALAXY Flip up 2 x 4¼” AUS
Instruction Manual
ENGLISH
SPERIAN Welding Protection AG
Industriestrasse 2
CH-9630 Wattwil
Tel : [phone]
Fax : [phone]
www.sperianprotection.com
V
Lic 1457
A
S/NZS 1337
9610.040.03 – 05.08 Printed in Switzerland
HIGH IMPACT APPROVED

!WARNING!
READ ALL INSTRUCTIONS AND WARNINGS
BEFORE USING PRODUCT. FAILURE TO FOLLOW
THESE WARNINGS MAY RESULT IN SERIOUS
INJURY OR BLINDNESS. DO NOT REMOVE ANY
PART OR MAKE ANY MODIFICATIONS TO THIS
PRODUCT. DO NOT USE THIS PRODUCT FOR
PROTECTION AGAINST LASER LIGHT.
!WARNING!
1. Welding can be dangerous. You can be hurt by fumes, rays,
electricity flame and hot metal. Failure to use adequate ventilation
can cause serious injury or death. Do not use this or any other
welding product unless you have been completely instructed on its
use by a competent and certified welding instructor.
2. This helmet is approved to High Impact under AS/NZS
1337:1992. Use this helmet only for face and secondary eye
protection against injurious rays, sparks, spatter, high energy flying
fragments and small particles caused during welding, machine disc
cutting, scaling, grinding and machining metals, as recommended
in table 4.2 AS/NZS 1336:1997 (Recommended practices for
occupational eye protection).
3. Pitted or scratched face plates reduce vision and seriously
reduce impact protection - replace immediately.
4. Inspect frequently and immediately replace worn or damaged
parts.
!WARNING! GB
2 x 4¼" Galaxy passive Flip up helmet
1 - Install clear cover plate into flip-up portion
2 - Install filter plate into flip-up portion (with the shade designation facing out)
3 - Install inside cover lens into flip-up portion
4 - Insert retention spring into flip-up portion
5 - Insert inside cover lens safety plate
6 - Insert adapter into helmet
7 - Push the adapter slide attachments into
place to secure the adapter in the helmet