Phonitor One 7
Do not place the device in a location where it may come into contact with corrosive gases
or salty air This may result in malfunction
Before moving the device, remove all connected cables
When setting up the device, make sure that the mains socket outlet you are using is easily
accessible If some trouble or malfunction occurs, immediately turn o the power switch
and disconnect the power supply from the mains socket outlet Even when the power
switch is turned o, electricity is still flowing to the product at a minimum rate When you
are not using the device for a long time, make sure to unplug the power supply from the
wall mains socket outlet
Connections
Before connecting the device to other devices, power down all devices Before power on or
o the devices, set all volume levels to minimum
Only use appropriate cables to connect the device with other devices Make sure that the
cables you use are intact and comply with the electrical specications of the connection
Other connections can lead to health risks and damage the equipment
Handling
Operate the controls and switches only as described in the manual Incorrect adjustments
outside safe parameters can lead to damage Never use excessive force on the switches or
controls
Do not insert your ngers or hands in any gaps or openings of the device
Avoid inserting or dropping foreign objects (paper, plastic, metal, etc ) into any gaps or
openings of the device If this happens, power down immediately and unplug the power
supply from the mains socket outlet Then have the device inspected by a qualied profes-
sional
Do not expose the device to excessive dust or vibrations or extreme cold or heat (such as
direct sunlight, near a heater or in a car during the day) to prevent the possibility of causing
damage to the housing, the internal components or unstable operation
If the ambient temperature of the device suddenly changes, condensation can occur (if for
example the device is relocated or is aected by a heater or air conditioning)
Using the device while condensation is present may result in malfunction Do not power on
the device for a few hours until the condensation is gone Only then it is safe to power on
Cleaning
Disconnect the power cord from the device before cleaning
Do not use any solvents, as these can damage the chassis nish Use a dry cloth, if neces-
sary, with an acid-free cleaning oil
Disclaimer
Windows® is a registered trademark of Microsoft® Corporation in the United States and
other countries
Apple, Mac and Macintosh are trademarks of Apple Inc , registered in the U S and other
countries
The company names and product names in this manual are the trademarks or registered
trademarks of their respective companies
SPL and the SPL Logo are registered trademarks of SPL electronics GmbH
SPL cannot be held responsible for damage caused by improper use or modication of the
device or data that is lost or destroyed
Notes on Environmental Protection
At the end of its operating life, this product must not be disposed with regular
household waste but must be returned to a collection point for the recycling of
electrical and electronic equipment
The wheelie bin symbol on the product, user manual and packaging indicates that
For proper treatment, recovery and recycling of old products, please take them to applica-
ble collection points in accordance with your national legislation and the Directives
2012/19/EU
The materials can be reused in accordance with their markings Through reuse, recycling of
raw materials, or other forms of recycling of old products, you are making an important
contribution to the protection of our environment
Your local administrative oce can advise you of the responsible waste disposal point
This directive only applies to countries inside the EU If you wish to discard devices outside
the EU, please contact your local authorities or dealer and ask for the correct method of
disposal
WEEE-Reg-No : 973 349 88
EN
DE
