Sport-thieme 145 7618 Manual

Operating/assembly instructions
Sport-Thieme kettlebell storage rack
Prod. code 145 7618
Page 1of 2
02/2016
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
!
!
Assembly instructions for the kettlebell storage rack
Thank you very much for choosing a product. We want to make sure
that you can enjoy this product, so here is some important advice for your safety as
well as for the use and maintenance of the equipment. Please read these
instructions fully before you assemble and use the equipment.
2
3
1
1
Ill. 1: Kettlebell storage rack
Included:
Pos. Description
1 2 x side section
2 2 x shelf with rubber cover
3 8 x coach bolt M8
4 8 x hex nut M8
5 8 x washer
1. General
The rack is used for the storage of kettle bells. The shelves !are covered with 4-
mm rubber mats to protect them against damage. They protect the rack as well as
the weights.

Operating/assembly instructions
Sport-Thieme kettlebell storage rack
Prod. code 145 7618
Page 2of 2
02/2016
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
!
!
The load should be evenly distributed and the maximum load for one shelf !is 150
kg.
The storage rack is only suitable for its intended use!
Ill. 2: Exploded view drawing
2. Assembly instructions
Place the sides "upright (see ill. 2), fix the two shelves !using bolt, washer and
nut #so that the rubber faces upwards.
Caution: Do not overload or climb the equipment!
Maintenance and care instructions
Instructions: Carry out a visual check at regular intervals. Due to our
continuous quality control of the products, technical changes
may occur which may lead to slight deviations in the
instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace
worn-out parts.
We are happy to answer any questions you may
have.
Your Sport-Thieme Team