Sport-thieme 167 8303 Manual

Operating/assembly instructions
Sport-Thieme hook-in volleyball posts
Prod. code: 167 8303; 167 8316
page 1of 3
04/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
!
!
Operating/assembly instructions
for hook-in volleyball posts
Thank you very much for choosing a Sport-Thieme product.
We want to make sure that you can enjoy this product, so here is some important
advice for your safety as well as for the use and maintenance of the equipment.
Please read these instructions fully before you assemble and
use the equipment:
Hook-in volleyball post with
tensioning device (167 8316)
Hook-in volleyball post
as counter post (167 8303)
1 x slider with
pulley
1 x slider
with hook
2 x slider
with hook
1 x tensioning device
with crank
1 x volleyball post
1 x base plate
1 x volleyball post
1 x base plate

Operating/assembly instructions
Sport-Thieme hook-in volleyball posts
Prod. code: 167 8303; 167 8316
page 2of 3
04/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
!
!
wall plate
slider with
pulley
tensioning device
slider with hook
hook-in volleyball
post
base plate
Wall
Ill. 1: Mounting dimensions
wall plugs
hex screws
Ill. 2: Wall plate
Ill. 3: Drilling diagram for the wall plate
Base plate
Wall
Ill. 4 : Distance from base plate to wall
!

Operating/assembly instructions
Sport-Thieme hook-in volleyball posts
Prod. code: 167 8303; 167 8316
page 3of 3
04/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
!
!
Assembly instructions
Following the dimensions shown in ill. 1 and 3, drill 2 holes into a stable wall and insert
the nylon wall plugs 14 into the drill holes. If you are not sure about the wall's quality,
please consult an expert.
Fix the wall plate to the wall using the hex screws 10.
After you have mounted the wall plate, mount the base plate vertically underneath
flush into the playing surface. The distance to the edge of the wall must be 230 mm
(ill. 4).
The base plate is fixed to the floor using 4 countersunk screws 5 x 30.
Attach the required sliders and the tensioning device to the volleyball post using the
locking screw.
You can now hang the posts from above into the mounted brackets.
On one side, the net is attached to the slider's hook of the counter post and then
prepared for playing by using the pulley and the tensioning device on the other side.
After playing, you can remove the net and unhook the posts. You will therefore
not interfere with the normal operation of the sports hall.
You can store the posts in the equipment room until you use them again.
Caution: Do not overload or climb the equipment!
Maintenance and care instructions
Instructions: Carry out a visual check at regular intervals. Due to our
continuous quality control of the products, technical changes
may occur which may lead to slight deviations in the
instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace worn-out
parts. Ensure that moveable parts are free-moving.
We are happy to answer any questions you may
have.
Your Sport-Thieme Team