Sport-thieme 115 2308 User manual

Assembly instructions
Sport-Thieme®
Fully Welded Mini Leisure Goal
Art.-Nr.: 115 2308
115 2337
115 2340
0218214 · © 2018 Sport-Thieme GmbH
D-38367 Grasleben ·Germany
sport-thieme.com · info @sport-thieme.com
Phone: [phone] · Fax: [phone]

2
Assembly instructions
for Art.-Nr. 115 2308/115 2337/115 2340
This goal is completely welded so that it need not to be assembled. However, it has always to be protected against overturning
according to DIN EN 15312 (see the information in chapter„ground xing“).
1. Scope of delivery
Please check the following content before assembly.
2. Ground xing
a) Ground bars and ground tube are equipped with 2 plates which serve to x the special anchoring system for the goal. Dierent
systems are available. The anchoring system is not part of the delivery.
The use of the goal without corresponding anchoring system is at your own risk.
The dimensions of the necessary foundations result from the distance of the plates, see the following drawings..
Do not use an accelerating admixture or antifreeze during setting in concrete as these may cause damages of the anchoring sys-
tems.
Concrete threaded bars M10 with thread protruding from the conrete. Place holes of the plates upon threaded bars, add washers
30 mm, screw and tighten nuts M10, DIN 985.
Foundation dimensions:

3
Assembly instructions
for Art.-Nr. 115 2308/115 2337/115 2340
b) Top view of ground xing for playground goal 1.20 x 0.80m: Art.-Nr. 115 2308
c) Top view of ground xing for playground goal 1.80 x 1.20m: Art.-Nr. 115 2337
d) Top view of ground xing for playground goal 2.40 x 1.60m: Art.-Nr. 115 2340
3. Maintenance, safety and storage instructions
Check screwed fastenings and possible damages regularly.
Notice: Due to our continuous quality check of products and equipment technical modications are possible.
This goal is constructed only for soccer matches and not for other purposes. Check all screwed
fastenings before use and repeat it from time to time. It has to protected against overturning at
any time.
It is not allowed to x additional parts or extensions at the goal frame which may impair the safety of the goal
(according to DIN EN 15312).
To avoid damage and misuse goals have to be stored secured and in an upright position when not in use.
Only use water for cleaning the surfaces. Do not use alcohol or any aggressive chemicals!