ST STM32F746IGT6 User manual

Core746I, STM32 MCU Core Board
Model:STM32F746IGT6
User Manual
What's on the Core746I:
1. STM32F746IGT6:the high performance STM32 MCU which features:
Core: Cortex-M7 32-bit RISC + FPU + Chrom-ART graphic accelerator
Feature: single-cycle DSP instructions
Operating Frequency: 216MHz, 462 DMIPS/2.14 DMIPS/MHz
Operating Voltage: 1.7V-3.6V
Package: LQFP176
Memories: 1024kB Flash, 320+16+4kB SRAM
MCU communication Interfaces:
- 6 x SPI, 4 x USART, 4 x UART, 3 x I2S, 4 x I2C
- 2 x CAN, 1 x QUAD-SPI, 1 x DCMI, 2 x SAI

- 1 x FMC, 1 x SDMMC, 14 x TIM , 1xLPTIM
- 1 xLCD-TFT, 1xSPDIFRX, 1xHDMI-CEC
- 1 x USB 2.0 OTG FS
- 1 x USB 2.0 OTG HS (supports external HS PHY through ULPI)
- 1 x 10/100 Ethernet MAC
AD & DA converters: 3 x AD (12-bit); 2 x DA (12-bit)
Debugging/Programming: supports JTAG/SWD interfaces, supports IAP
2. IC42S16400J / IS42S16400J: SDRAM 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT)
3. MIC2075: onboard USB power management device
4. AMS1117-3.3: 3.3V voltage regulator
5. 8M crystal
6. 32.768K crystal, for internal RTC with calibration
7. Reset button
8. VBUS LED
9. Power indicator
10. Power supply switch, powered from 5Vin or USB connection
11. Boot mode selection, for configuring BOOT0 pin
12. JTAG/SWD interface: for debugging/programming
13. USB connector, supports Device and/or Host
14. MCU pins expander, VCC, GND and all the I/O pins are accessible on expansion connectors for
further expansion
15. Power jumper
VBAT: short the jumper to use system power supply, open it to connect external power, such as
battery
VREF: short the jumper to connect VREF+ to VCC, open it to connect VREF+ to other custom pin via
jumper wire
16. OTG jumper
short the jumper when using USB OTG/HOST
open the jumper to disconnect from related I/O port
Note: Core746I provides JTAG/SWD debugging interface, yet does NOT integrate any debugging
function, a debugger is required.
JTAG/SWD interfaces
The figure 1, and 2 show the header pinouts of JTAG/SWD interface
Figure 1. JTAG Header Pinout Figure 2. SWD Header Pinout