Stamina Versabell User manual

This Product is Produced Exclusively by
2040 N. Alliance, Springeld, MO 65803
Customer Service
1 [phone]
[email protected]
www.staminaproducts.com
When calling for parts or
service, please specify the
following number:
05 -3036
Safety Instructions
Customer Service
Operation
Warranty
Owner's
Manual
Patent No. US 7,491,157 B1.
Other patent(s) apply & are pending.
SAFETY INSTRUCTIONS
!WARNING: To reduce the risk of serious injury, read the following Safety Instructions
before using the KETTLE VERSABELL®.
1. Read this Owner’s Manual and follow it carefully before using the KETTLE VERSABELL®.
2. Keep children away from the KETTLE VERSABELL®. Do not allow children to use or play around the
KETTLE VERSABELL®. Keep children and pets away from the KETTLE VERSABELL® when it is in use.
3. Make sure that there is adequate space around your workout area when using the KETTLE VERSABELL®.
Be careful not to strike any objects or the oor while using the KETTLE VERSABELL® as damage to the
product or injury may occur.
4. Inspect the KETTLE VERSABELL® for damaged or loose components prior to use.
5. Tighten/replace any loose or worn components prior to using the KETTLE VERSABELL®.
6. Before exercising, check the Selector Pin(9) to verify that it is fully inserted into the adjustment hole to
properly secure Weight Plates(10). Check the Bumper(5) to ensure it is properly covering the Selector
Pin(9). Falling weights can result in severe injury.
CAUTION: Never adjust the Selector Pin(9) when the KETTLE VERSABELL® is removed from its
WEIGHT BASE(11) and the FLOOR PAD(28).
7. Consult a physician prior to commencing an exercise program. If at any time during exercise you feel faint,
dizzy, or experience pain, stop and consult your physician.
8. Always choose the workout which best ts your physical strength and exibility level. Know your limits and
train within them. Always use common sense when exercising.
9. Do not wear loose or dangling clothing while using the KETTLE VERSABELL®.
10. The KETTLE VERSABELL® is for consumer use only. It is not for use in public or semipublic facilities.
MADE IN CHINA
2010 Stamina Products, Inc.
2010, 01

1. Top Cap 1
2. Handlebar 1
3. Upper Dome 1
4. Lower Dome 1
5. Bumper 1
6. Inner Ring 1
7. Outer Ring 1
8. Selector Rod 1
9. Selector Pin 1
10. Weight Plate 4
11. Weight Base 1
12. Weight Guide 2
13. Magnet 1
14. Screw, Flat Head (M2.5x0.45x20mm) 9
15. Bolt, Socket Head (M5 x 0.8 x 30mm) 8
16. Bolt, Socket Head (M6 x 1 x 18mm) 8
17. Nylock Nut (M2.5 x 0.45) 9
18. Nylock Nut (M12 x 1.75) 2
19. Nylock Nut (M16 x 2) 1
20. Lock Washer (M5) 8
21. Lock Washer (M6) 8
22. Lock Washer (M12) 2
23. Lock Washer (M16) 1
Part No. and Description Qty
Products shipped to the manufacturer must be in the original shipping carton with freight prepaid. All expenses for
repairing or replacing the product, including the cost of shipping it back to the original purchaser, will be covered by the
manufacturer. This warranty gives you specic legal rights, and you may have other rights which vary from state to state.
If the product should, for any reason, become defective within 90 days of purchase, the manufacturer will replace
the product once it is returned to the manufacturer. This warranty does not apply to any damage caused by accident,
return transit, alteration, abuse, or misuse. There are no other warranties other than those expressly set forth herein.
This product is warranted to be free from defects in material and workmanship and to be in perfect working order at
the time of purchase. This warranty applies to personal, family or household use. This warranty does not apply to
use in athletic clubs, health clubs, spas, gymnasiums, exercise facilities, and other public or semipublic facilities.
LIMITED WARRANTY
1. While on the FLOOR PAD(28), pull the BUMPER(5) down.
Change the workout weight by pulling out the SELECTOR
PIN(9), then re-inserting the SELECTOR PIN(9) into the
desired adjustment hole. The weight number at the side of
the selected hole shows the amount of weight selected for the
workout. Push the BUMPER(5) back to the closed position.
The
KETTLE VERSABELL® has an internal selector rod
device that allows the user to adjust the weights by using the
SELECTOR PIN(9). Follow the steps below to adjust and work
out with your KETTLE VERSABELL® :
OPERATIONAL INSTRUCTIONS
24. Washer (M2.5) 9
25. Washer (M6) 8
26. Washer (M12) 2
27. Washer (M16) 1
28. Floor Pad 1
29. Manual (not pictured) 1
2. Lift the
KETTLE VERSABELL®
to begin the workout. The weight plates which
are not selected will stay on the FLOOR PAD(28).
After the workout, always put the
KETTLE VERSABELL®
back on to the top
of the unused weight plates on the FLOOR PAD(28).
CAUTION: Never adjust the SELECTOR PIN(9) when the
KETTLE
VERSABELL® is removed from the FLOOR PAD(28) and the WEIGHT
PLATES(10) and WEIGHT BASE(11).
16
20
24
28
32
36
Weight number in pounds
Weight
Plates