StarTech.com SATADOCKU2E User manual

Manual Revision: 03/28/2012
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
SATADOCKU2E
SATDOCKU2EGB
SATDOCKU2EEU
USB 2.0/eSATA to 2.5”/3.5” SATA HDD Dock
*actual product may vary from photos

Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use ofTrademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.

Instruction Manual
i
Table of Contents
Introduction ...........................................................................................1
Features ........................................................................................................................................................ 1
Package Contents ..................................................................................................................................... 1
Disk Installation......................................................................................2
SATA Drive Removal...............................................................................2
Preparing the Hard Drives for Use.......................................................3
Specications..........................................................................................6
Technical Support ..................................................................................7
Warranty Information............................................................................7

Instruction Manual
1
Introduction
This eSATA/USB to SATA External HDD Dock Adapter provides immediate, swappable
access to any 2.5in or 3.5in SATA (SATA, SATA II, SATA III) hard drive (HDD) or solid state
drive (SSD) - without having to mount the hard drive, or install it in an enclosure!
Simply connect this docking station to a computer using either eSATA or USB 2.0, and it’s
as simple as inserting your 2.5in or 3.5in SATA hard drive into the dock whenever needed.
A perfect solution for data recovery, drive imaging, and testing centers, or any
environment that requires fast access to uninstalled/archived drives, the SATA HDD Dock
supports plug and play installation on most operating systems. Plus, the HDD docking
station supports data transfer speeds of up to 1.5 Gbps (using eSATA) and 480Mbps
(using USB 2.0) between host and dock - ensuring eortless data dumps, backups and
hassle-free le transfers. Double the value of this hard drive docking station, using a
SATA to IDE hard drive adapter (SAT2IDEADP), which enables you to use any 2.5 or 3.5in
IDE hard drive in a SATA hard drive dock slot.
Features
• Hot Swap Compatible
• Plug and Play support for most operating systems
• Supports both SATA 2.5” and SATA 3.5” hard drives without any adapters
• Supports SATA I/II/III (SATA 150/300/600)
Package Contents
• 1x SATA hard drive docking station
• 1x USB Cable
• 1x eSATA Cable
• 1x Power Adapter
• 1x Instruction Manual

Instruction Manual
2
Rear View
DC Power
Adapter
eSATA
Port
On/O
Switch
USB
Port
Disk Installation
1. Connect the Dock to an available power outlet, using the provided power adapter.
2.
Connect the Dock to the (powered) Host Computer, using the provided USB/eSATA cables.
3. Insert the 2.5” or 3.5” SATA/SATA II drive(s) you wish to install, such that the SATA
power and data connectors at the back of the drive are properly aligned with the
corresponding connectors inside the Dock.
4. Switch the power switch to “ON” position.
5. Once the drive has been inserted, the operating system will detect that it has been
connected and automatically update the drivers for proper operation.
SATA Drive Removal
You can remove SATA drives from the docking station by gently pulling them out from
the top of the dock.

Instruction Manual
3
Preparing the Hard Drives for Use
1. With the hard drives inserted and the dock powered on, right click on the My
Computer icon and select Manage. In the left pane of the Computer Management
window, click Disk Management.
2. In the bottom right pane of the Computer Management window, you should see
your drives listed as unallocated. Click on the unallocated drive and select New
Partition. The New Partition Wizard will launch.
3. When the New Partition Wizard appears, click Next to continue

Instruction Manual
4
4. Select the partition type you wish to create by clicking on Primary or Extended, as
appropriate. When you have made your selection, click Next to continue.
5. Specify the size of the partition you wish to create. You must select a partition size
that is between the maximum and minimum sizes (typically the maximum disk
space available). Once you have done so, click Next to continue.
6. Select Format this partition with the following settings. Using the drop down
buttons, select the le system, allocation unit size, and volume label you wish to use.
Select Perform a Quick Format and click Next to continue.

Instruction Manual
5
7. A notication window will appear indicating that you have successfully completed
the New Partition Wizard. Click Finish to commence the formatting of the drive.
8. The status of the drive, as shown in the Computer Management window, will be
updated to reect the selections you have made. Please wait while the drive is being
formatted.
9. Once the drive has been successfully partitioned and formatted, it will display as
Healthy.

Instruction Manual
6
10. To access your newly partitioned drive(s), open My Computer. Your drive(s) should
be displayed below the heading Hard Disk Drives.
Specications
Specication SATADOCKU2E/SATDOCKU2EEU/SATDOCKU2EGB
Internal
Connectors
1 x SATA Power 15-Pin Female
1 x SATA Data 7-Pin Female
External
Connectors
1 x USB B Female
1 x eSATA Plug Female
1 x DC Power Adapter
Drive
Compatibility 2.5/3.5” SATA Hard Drives
OS Support
Windows 98SE/ME/2000/2003/XP/Vista™/7 (32 and 64
bit) x64/x86, Mac OS 10.0 and up, Linux RedHat 9 &
Fedora FC4/FC5
Power Adapter 12V 2.0A

Instruction Manual
7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.

Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.