Status Instruments SEM206/P User manual

IMPORTANT - CE & SAFETY REQUIREMENTS
Product must be mounted, inside a suitable enclosure providing environmental protection to IP65 or greater.
To maintain CE EMC requirements , input wires must be less than metres.
The product contains no serviceable parts , or internal adjustments. no attempt must be made to repair this product. Faulty units must be returned to supplier for repair.
This product must be installed by a qualified person. All electrical wiring must be carried out in accordance with the appropriate regulations for the place of installation.
Before attempting any electrical connection work, please ensure all supplies are switched off.
ABSOLUTE MAXIMUM CONDITIONS ( To exceed may cause damage to the unit) :-
Supply Voltage ± 0 V dc (Protected for over voltage and reverse connection)
Current with over voltage ± 100 mA
Input Voltage ± V between any terminals
Ambient Temperature (-40 to 85) °C Humidity (10 to 95) % RH (Non condensing)
SEM206/P USER GUIDE
SMART HEAD MOUNTED TRANSMITTER INPUT PT100
TWO WIRE (4 to 20) mA
Every effort ha been taken to en ure the accuracy of thi document, however we do not accept re pon ibility for damage, injury, lo or expen e re ulting from error and omi ion , and we re erve the right of amendment without notice.
Important - Please read this document be ore any installing.
PRODUCT SPECIFICATION
RECEIVE AND UNPACKING
CONFIGURATION
Please refer to the product data sheet for full specification, available to down load at www.status.co.uk.
Please inspect the packaging and instrument thoroughly for any signs of transit damage. If the instrument has been damaged, please notify your supplier immediately.
The following parame er can be configured by simply en ering as promp ed by he sof ware package.
· Low range
· High range
· Uni s (°C, °F)
· Burnou (direc ion of ou pu curren on sensor burnou )
Factory default:
Low Range 0
High Range 100
Units °C
Burnout UPSCALE
Inpu PT100
1
2
3
2 Wire (4 o 20) mA
Ou pu
SEM206 P
+
-
V
s
Loop
Load
+
-
IMPORTANT Do not attempt to configure the SEM206 P when connected to a loop supply.
COMMS
Download @
www.status.co.uk
SEM206 P
USB SPEEDLINK
COMPUTER
USB CABLE
STATUS USB CONFIG-UNIT
Red +
Black -
CONFIGURATOR
Status Instruments Ltd, Status Business Park, Gannaway Lane, Tewkesbury, Gloucestershire, UK, GL20 8FD
Web Page: www.status.co.uk email : [e-mail] Technical Support : [e-mail]
Tel : [phone] Fax: [phone]
D2459_01_04 CN516 SEM206P _User_Guide

SUPPLY (Vs) (10 to 30) V dc
MAX LOAD Ohms (Vs - 10) / 0.021
OUTPUT
2 Wire (4 o 20) mA
INPUT CONNECTION
PT100 wire mus be equal leng h and ype .
To main ain CE compliance cable leng h mus be less han
3 Me res.
OUTPUT CONNECTION
Use wis ed pair or screened cables for cable leng hs
grea er han 30 Me res. Max cable leng h 1000 Me res.
Ensure loop is grounded a one poin .
Ø 3mm
ELECTRICAL INSTALLATION
Screw Driver
TURN OFF SUPPLY BEFORE WORKING ON ANY ELECTRICAL CONNECTION
Vs
Loop
Load
+
-
1
2
3
+
-
INPUT
PT100
D2459_01_04 CN516 SEM206P _User_Guide