Stelpro SDC Series User manual
INSSDC1213
S
Y
S
T
È
M
E
Q
U
A
L
I
T
É
C
E
R
T
I
F
I
É
-
R
E
G
I
S
T
E
R
E
D
Q
U
A
L
I
T
Y
S
Y
S
T
E
M
USER’S GUIDE
SDC SERIES
COMMERCIAL AIR CURTAIN
This unit
complies with
the CSA
standards
For further information or to consult this guide online, please visit our website at www.stelpro.com
Before installing and operating this product, the user and/or installer must read, understand and follow these instructions and keep them handy for future refer-
ence. If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further responsibility for this product.
, according to the effective
in your region.
The following instructions must be adhered to in order to avoid personal injuries or property damages, serious injuries and potentially fatal electric shocks.
Make sure that all screws and electrical terminal connections are tightly secured before operating the unit in case they would have loosened during trans-
portation.
Protect the heating unit with the appropriate circuit breaker or fuse, in accordance with the nameplate.
Make sure the line voltage (volt) is consistent with that indicated on the unit’s nameplate.
This unit must be .
Switch off the power at the circuit breaker/fuse before installing, repairing and cleaning the unit.
Make sure the unit is appropriate for the intended use (if needed, refer to the product catalog or a representative).
It corresponds to based on a standard ceiling height of 8 feet (2.44 m).
Do not install the unit where objects or pieces of furniture could be heat damaged.
indicated in the installation section.
This unit must not come into contact with a water source and must be protected from splashes (e.g. a wet mop). Do not use it if any part has been immersed.
Moreover, do not turn it on or off when standing in water or if your hands are wet.
When cutting or drilling into a wall, do not damage electrical wiring and other hidden utilities.
Do not install this product on walls made of synthetic material such as, but not limited to, carpet and wallpaper.
WARNING
REPLACEMENT COMPONENT LIST INCLUDED
APPAREIL
/ UNIT:
MIS À JOUR
UPDATED:
DESSIN TECHNIQUE / TECHNICAL DRAWING
DESSINATEUR
/ DRAFTER:
DATE: 30/11/2011 SDC
A. DESMARAIS AD_25/10/2013
2INSSDC1213
24 V CONTROL VOLTS PH. BTU MM IN. KG LB LFM
SDC0581C24 5000/2500 208 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0583C24 5000/2500 208 3 10239/17065 613 24 1/8 23,6 52 1500
SDC0521C24 5000/2500 240 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0571C24 5000/2500 277 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0531C24 5000/2500 347 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0551C24 5000/2500 480 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0553C24 5000/2500 480 3 10239/17065 613 24 1/8 23,6 52 1500
SDC0561C24 5000/2500 600 1 10239/17065 613 24 1/8 23,6 52 1500
SDC0563C24 5000/2500 600 3 10239/17065 613 24 1/8 23,6 52 1500
for white or for almond. Please consult our product catalog to know the other available options.
Because this unit is hot when in use, it may pose risks even in normal operation. Therefore, be and when using it. To avoid burns, do
not let bare skin touch hot surfaces. Let the unit cool down for few minutes before handling (it will stay warm for some time after shut-down).
It is the user’s responsibility to ensure that objects including, but not limited to, shelves or plastic containers do not come in contact with the unit and to keep
them at least 24 inches (61 cm) from the unit.
products.
Some areas are dustier than others. Thus, it is the user’s responsibility to evaluate if the unit must be cleaned based on the amount of dirt accumulated on
Thermal protection activation indicates that the unit has been subjected to abnormal operating conditions. If the thermal protection remains activated or
damaged. (Refer to the limited warranty)
WARNING
instances, the instruction manual may not entirely match all the functions of the actual product. Therefore, the actual product and packaging, as well as the name
and illustration, may differ from the manual.
SPECIFICATIONS
TECHNICAL DRAWINGS
FRONT
TOP
5/8"
16mm
9/16"
14mm
1 3/4"
45mm
O7/8"
22mm
KO
O
3/8"
10mm
KO
3 7/16"
88mm
10 5/8"
270mm
16 13/16"
427mm
24 1/8"
613mm
11/16"
17mm
1"
25mm
1 3/16"
30mm
O3/8"
10mm
KO
7 1/16"
179mm
WALL SUPPORT
SIDE
SWITCH (HIGH/LOW)
SWITCH (ON/OFF)
SWITCH (HEAT/FAN)
THERMOSTAT
4"
102mm
12"
305mm
O7/8"
22mm
KO
1"
25mm
INSTALLATION
SUPPLIED PARTS
3INSSDC1213
1
2
RODS (NOT INCLUDED) INTO THE
FOUR CORNERS OF THE UNIT.
4
WEIGHT OF THE UNIT. IF NEEDED, SOLIDIFY IT. THEN, DRILL FOUR (4)
HOLES INTO THE CEILING (5/8”) IN ORDER TO INSERT THE RODS.
5
6-
7CHECK IF THE UNIT RUNS PROPERLY.
8
1SECURE THE FOUR (4) MOUNTING
THE PROVIDED SCREWS.
2
4
5
SCREWS. (SEE FIG. 2)
6-
7CHECK IF THE UNIT RUNS PROPERLY.
8
fIgURE 1
fIgURE 2
1
2
OF THE STUDS.
-
ETS TO THE UNIT USING THE PROVIDED
SCREWS.
4
5FIX THE UNIT TO THE STUDS USING TWO SELF-DRILLING SCREWS (SCREW THEM INTO THE HOLES
6
7
8CHECK IF THE UNIT RUNS PROPERLY.
according to windows height
1 1/2"
[38 mm]
1"
[25 mm]
1"
[25 mm]
1 1/4"
[32 mm]
5 1/2"
[140 mm]
1/4"
[6 mm]
KOE Ø
fIgURE 4 fIgURE 5 fIgURE 6
fIgURE 3
fIgURE 7 fIgURE 8
4INSSDC1213
Switch off the main breaker in the electrical panel before cleaning the unit. Use
a soft rag for dusting. When cleaning, use only a damp rag and non-abrasive
dish soap. Do not use abrasive or chemical cleaners because they may damage
remove dust and other foreign objects from the grilles. If needed, vacuum out
the dust inside the unit. Note that cigarette smoke could yellow the discharge
grille and that the best way to prevent it is to clean the unit on a regular basis.
MAINTENANCE
TROUBLESHOOTING
The unit does not come on
The circuit breaker is in the OFF position
Open circuit breaker or fuse
The thermal protection has been activated
Faulty connections
Defective transformer
The unit becomes extremely hot
The unit cycles under control of the thermal protection or it is defective
Blocked air vents
Defective motor
The unit cycles under control of the thermal protection
(overheat indicator)
Blocked air vents
Defective motor
The breaker trips when the heater is turned on Faulty connections
Voltage lower than that written on the nameplate
Elements are on, but the motor does not run Defective motor
OPERATION
ON OFF HI
TURNS ON TURNS OFF FULL POWER,
LOW
REDUCED FLOW
N.B. If you do not solve the problem after checking these points, cut off the power supply at the main electrical panel and contact our customer service (see the
“Limited warranty” section to obtain the phone numbers).
5INSSDC1213
1 CONT-3002
1 CONT-3022
1 CONT-3503
1 CONT-4023
2 MO-026 MOTOR 1/5HP 208/240 V
3 PROT-005
4 TRF200025
4 TRF300025
4 TRF320025
4 TRF320250
4 TRF600025
4 TRF620250
4TRF200040D
5 HOLD-005 FUSE HOLDER 2 POLES 600V
6 FS-005
REPLACEMENT COMPONENT LIST
1
4
2
3
5
6
6INSSDC1213
This limited warranty is offered by Stelpro Design Inc. (“Stelpro”) and applies to the following product made by Stelpro: model SDC.
, Stelpro warrants its products and their components against defects in
workmanship and/or materials for the following periods from the date of purchase:. This warranty applies only to the original purchaser; it is
non-transferable and cannot be extended.
If at any time during the warranty period the unit becomes defective, you must cut off the power supply at the main electrical panel and contact 1) your
installer or distributor, 2) your service center or 3) Stelpro’s customer service department. In all cases, you must have a and
provide the . Stelpro reserves the right to examine or to ask one of its representatives to examine
the product itself or any part of it before honoring the warranty. Stelpro reserves the right to replace the entire unit, refund its purchase price or repair a
(electricians and distributors - French), (electricians and distributors - English), or (consumers).
This warranty is exclusive and in lieu of all other representations and warranties (except of title), expressed or implied, and Stelpro expressly disclaims
Stelpro’s liability with respect to products is limited as provided above. Stelpro shall not be subject to any other obligations or liabilities whatsoever,
whether based on contract, tort or other theories of law, with respect to goods or services furnished by it, or any undertakings, acts or omissions relat-
ing thereto. Without limiting the generality of the foregoing, Stelpro expressly disclaims any liability for property or personal injury damages, penalties,
-
disclaims all consequential, incidental and contingent damages whatsoever.
This warranty does not cover any damages or failures resulting from: 1) a faulty installation or improper storage; 2) an abusive or abnormal use, lack of
maintenance, improper maintenance (other than that prescribed by Stelpro) or a use other than that for which the unit was designed; 3) a natural disas-
water damages, etc. This warranty does not cover any accidental or intentional losses or damages, nor does it cover damages caused by negligence
of the user or owner of the product. Moreover, it does not cover the cost of disconnection, transport, and installation.
The warranty is limited to the repair or the replacement of the unit or the refund of its purchase price,
warranty will be considered null and void and Stelpro will have the right to refuse any claims if without the written autho-
-
oration caused by excessive heat, chemical cleaning products and abrasive agents. It does not cover any damage that occurred during the shipping.
Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages and some of them do not allow limitations
may have other rights which vary from state to state or from province to province.
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY
STELPRO DESIgN INC. | Saint-Bruno-de-Montarville | Québec | J3V 6L7
This manual suits for next models
9
Table of contents
Other Stelpro Heater manuals
Stelpro
Stelpro SK series User manual
Stelpro
Stelpro Pulsair ARWF series User manual
Stelpro
Stelpro WFA1502 User manual
Stelpro
Stelpro FI605 User manual
Stelpro
Stelpro UNIWATT AZUR UAC 01 Series User manual
Stelpro
Stelpro SIL2030 series User manual
Stelpro
Stelpro SPIDER ASGH4002 User manual
Stelpro
Stelpro SDHR Series User manual
Stelpro
Stelpro AALUX2 SERIES User manual
Stelpro
Stelpro PDH’ series User manual
Stelpro
Stelpro Prima ASPRM1752W User manual
Stelpro
Stelpro ACW1000930 Series User manual
Stelpro
Stelpro SILBH2060 SERIES User manual
Stelpro
Stelpro PRIMA SPR Series User manual
Stelpro
Stelpro AALUX3 Series User manual
Stelpro
Stelpro SCRSP Series Assembly instructions
Stelpro
Stelpro ASIL2030 Series User manual
Stelpro
Stelpro LCH48T User manual
Stelpro
Stelpro CW750-CW1000 User manual
Stelpro
Stelpro SDH Series User manual
Popular Heater manuals by other brands
P.Lindberg
P.Lindberg 9051422 Original manual
Russell Hobbs
Russell Hobbs RHOFR3001 manual
Fenix
Fenix GR 300 Mounting and operating instructions
solamagic
solamagic IR 02004 Installation and instruction manual
Parker
Parker Racor GreenMAX 4400 Series Installation and service instructions
Hendi
Hendi 273869 user manual
