Streetwize SWBCG4 User manual

12Volt 4Amp & 6Amp
Battery Charger
SWBCG6
SWBCG4
Please read these instructions carefully before operating this battery charger.
Part No. Rated Output Battery Voltage Battery Capacity
SWBCG4 4 Amp 12 Volt 12-48 Ah
SWBCG6 6 Amp 12 Volt 20-80 Ah
SWBCG4 & 6 Manual AW 2018.qxp_Layout 1 29/03/2019 11:26 Page 2

Battery Maintenance:
Please check your car battery regularly throughout the year and especially in
the winter.
Faulty cells can cause problems with your battery, check the cells with a
hydrometer, if any cell is reading lower than the others it can indicate a faulty
cell. if this is the case have your battery checked, as you may need a new
battery. It is possible that a battery may appear flat when it could simply be a
loose connection of the battery terminals. Check the terminals and tighten if
necessary then check the battery again.
To enable safe operation of this battery charger, make sure you follow basic
safety principles to reduce a risk of personal injury, electric shock and fire.
Always ensure the battery charger is kept in a dry place to avoid damage, and
store out of the reach of children. Do not use the charger in damp or wet areas
as moisture will damage the transformer.
Always check the battery chargers plug, cables and crocodile clips before use.
Do not open the charger, there are no serviceable parts.
When charging, the liquid in the battery may bubble causing a release of gas,
this is flammable so always operate the charger in a well ventilated place and
away from naked flames and sparks.
Do not leave the battery charger whilst in operation for long periods of time.
These chargers are only suitable for 12 Volt Lead-Acid batteries and
should not be used to recharge NICAD or any other type of battery.
DANGER: Avoid getting battery acid (electrolyte) on your skin or clothing,
as it may cause burns. If this occurs rinse immediately with cold water
and if necessary seek medical advice.
Please Note: There may be no indication of the Amp Meter needle if the
charger is connected to a fully charged battery.
The charger contains a temperature-sensitive switch that automatically
cuts off when the charger is overloaded or becomes excessively hot. The
charger will switch back on after the unit has cooled.
Safety Instructions:
FOR INDOOR USE ONLY.
SWBCG4 & BCG6 Manual AW 2016_Layout 1 01/07/2016 08:59 Page 3
SWBCG4 & 6 Manual AW 2018.qxp_Layout 1 29/03/2019 11:26 Page 3

IMPORTANT OPERATING INFO:
5. Plug the Charger in using a fused AC mains plug socket.
When a battery is first connected, the Amp Meter will indicate
that it is charging (needle points to the right, Fig 1), as the
battery becomes charged the charging rate will drop/discharge.
When the charging level is constant (needle points to the left, Fig 2),
the battery is fully charged to it’s optimum level.
Please note: The Amp Meter will never drop to zero during
charging. The Battery Charger has Reverse Polarity Protection
if the leads are incorrectly connected the Amp Meter the
needle will swing back and forth continuously, IMMEDIATELY
unplug the charger from the mains and reverse the connection.
Fig 2
Fig 1
Operating Instructions:
Please read the information on the front of these instructions for the maximum
battery capacity recommended for use with this charger. Using with batteries
smaller/higher than this capacity may lead to damage of battery and/or charger.
1. Disconnect the Battery from the vehicle to avoid damage to the alternator.
It is advisable where possible to remove the battery from the vehicle as
spillage from the battery can cause damage.
2. If you have a maintenance free/sealed battery it is not necessary to carry
out the following checks. Carefully remove all the caps from each battery
cell, and ensure the liquid is at the recommended level. Top up with
distilled or de-ionised water if required (ALWAYS wear protective gloves as
this liquid is corrosive). Tap water should NOT be used under any
circumstances, allow time for any gases to escape before replacing the
caps. Warning: if your battery is the AUTOFIL type, manufactured by
Dagenite or Exide, the glass balls and the long filler cap MUST be left in
place during charging.
3. DO NOT plug the charger in until you have connected the crocodile clips
correctly.
4. Connect the crocodile clips in the following order.
a) Connect the positive (+ Red) charging lead to the positive
(+ Red) terminal.
b) Connect the negative (- Black) charging lead to the negative
(- Black) terminal.
It is important that the crocodile clips are making good contact with the
battery terminals.
TROUBLESHOOTING: If Battery Charger does not work in the first instance
please replace the “flat” blade car type fuse located on the base of the charger
with the spare blade fuse supplied.
SWBCG4 & 6 Manual AW 2018.qxp_Layout 1 29/03/2019 11:26 Page 4

RoHS
COMPLIANT
M17 1RY
6. To disconnect the battery when charged, switch off the mains supply and
unplug. Caution: Because of risk of explosive gas, only disconnect the
crocodile clips when the mains are disconnected. Check the fluid levels and
top up if necessary and wipe the battery clean. If the battery has been
removed, replace in the vehicle and re-connect.
Product Specifications:
Streetwize Part Number: SWBCG4
Voltage Rating Input: 230V 50Hz
Output Rating: 12v DC - 2.8 ADC equal to 4 Amp RMS
Streetwize Part Number: SWBCG6
Voltage Rating Input: 230V 50Hz
Output Rating: 12v DC - 4.2 ADC equal to 6 Amp RMS
The WEEE symbol on this product means that this product should be
ethically dismantled or recycled to minimise environmental impact.
Please check with your local authority for more information.
IMPORTANT: ADDITIONAL SAFETY INFORMATION
This Battery Charger is NOT intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are supervised or have been given instruction
concerning use of the Battery Charger by a person responsible for their safety.
FOR INDOOR USE ONLY
SWBCG4 & BCG6 Manual AW 2016_Layout 1 01/07/2016 08:59 Page 1
WARRANTY: The 12 month warranty on this product will need to be activated within
30 days of purchase, please go to our web site and click on the “Warranty” link and
enter your details on the warranty screen. www.streetwizeaccessories.com.
Streetwize Accessories:
Unit 1, Royce Trading Estate, Ashburton Road West,
Trafford Park, Manchester M17 1RY
Sales enquiries: [email protected]
Technical enquiries: [email protected]
Telephone: [phone]
www.streetwizeaccessories.com
SWBCG4 & 6 Manual AW 2018.qxp_Layout 1 29/03/2019 11:26 Page 1