GreenWorks Commercial 82CH62K User manual

1 Description......................................... 2
1.1 Overview........................................................... 2
2 Important Safety Instructions..........2
3 Special rules for charger...................2
4 Proposition 65.................................... 3
5 Symbols on the machine................... 3
6 Risk levels...........................................3
7 Operation........................................... 3
7.1 Charge procedure...............................................3
7.2 Charging tip....................................................... 4
7.3 Examine the charger.......................................... 4
8 Maintenance.......................................4
8.1 Clean the machine............................................. 4
9 Transportation and storage.............. 5
9.1 Move the machine............................................. 5
9.2 Store the machine.............................................. 5
10 Troubleshooting................................. 5
11 Technical data....................................5
12 Limited warranty.............................. 6
1
English EN

1 DESCRIPTION
1.1 OVERVIEW
Figure 1
1Handle
2Battery cover
3Air vents
4Lower frame
5Cord retainer
6Wheels
2 IMPORTANT SAFETY
INSTRUCTIONS
WARNING
TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK,
CAREFULLY OBEY THESE INSTRUCTIONS.
• Do not cover the ventilation slots on the top of the
charger. Do not set the charger on a soft surface i.e.
blanket, pillow. Keep the ventilation slots of the charger
clear.
• Confirm the voltage availability at each country location
before using the charger.
• If the shape of the plug does not fit the power outlet, use
an attachment plug adaptor of the proper configuration
for the power outlet.
• DO NOT allow liquid inside the charger.
• DO NOT try to use the charger for any other purpose than
what is presented in this manual.
• Unplug the charger and remove the battery pack before
cleaning.
• Do not try to connect two chargers together.
• Do not use the charger in the circumstances that the
output polarity does not match the load polarity.
• Do not place the battery pack in the sun or in a warm
environment. Keep at normal room temperature between
42.8 °F and 104°F.
• Do not allow small metal items or material such as steel
wool, aluminum foil, or other foreign particles into the
charger cavity.
• Do not attempt to recharge non-rechargeable batteries
with the charger.
• SAVE THESE INSTRUCTIONS – This manual contains
important safety and operating instructions for battery
charger Model 82CH62K.
• Before using battery charger, read all instructions and
cautionary markings on battery charger, battery, and
product using battery.
• CAUTION – To reduce risk of injury, use only 82BD250
or Greenworks 82V series approved replacement
batteries. Other types of batteries may burst causing
personal injury and damage.
• This appliance can be used by children 8 years of age and
older. Individuals with reduced physical, sensory or
mental capabilities or lack of experience and knowledge,
should only use this appliance with supervision, and/or
proper instruction concerning the use of this appliance in
a safe way and understand all hazards. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• If the cord set is damaged, it must be replaced by a
special cord set available form the manufacturer or its
service agent.
WARNING
To avoid risk of fire, electrical shock, or electrocution:
• Do not use a damp cloth or detergent on the battery or
battery charger.
• Battery should be no where near a water source
• Always remove the battery pack before cleaning,
inspecting, or performing any maintenance on the tool.
3 SPECIAL RULES FOR
CHARGER
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
• Appliance shall not emit harmful radiation or present a
toxic or similiar hazard due to their operation in normal
use.
• This device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
2
English
EN

NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio or television reception. The reception
can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
4 PROPOSITION 65
WARNING
This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
5 SYMBOLS ON THE MACHINE
You can use below symbols on the machine. Please study
them and learn their definitions. Correct interpretation of
these symbols let you operate the tool better and safer.
Symbol Explanation
Before charging, read the instructions
Fuse
IPX IPX4
6 RISK LEVELS
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
SYM-
BOL
SIGNAL MEANING
DANGER Indicates an imminently haz-
ardous situation, which, if not
avoided, will result in death
or serious injury.
WARNING Indicates a potentially hazard-
ous situation, which, if not
avoided, could result in death
or serious injury.
CAUTION Indicates a potentially hazard-
ous situation, which, if not
avoided, may result in minor
or moderate injury.
CAUTION (Without Safety Alert Sym-
bol) Indicates a situation that
may result in property dam-
age.
7 OPERATION
7.1 CHARGE PROCEDURE
NOTE
Before use charge the battery pack fully to make sure that
the battery pack can get the maximum run time. This battery
pack does not have a memory. You can charge it all the
time.
1. Connect the plug of charger to an AC power outlet.
2. Lift the battery cover (2) by pushing the cover release
button (8).
3. Put the battery pack (9) (not included) into the charger.
NOTE
Push the battery release button (10) to take out the
battery.
3
English EN

This is a diagnostic charger. The Charger LED Light (7)
illuminates in a specified order to show the current battery
status. They are as follows:
CHARGING PROCEDURE (LED
INDICATOR)
BATTERY IS CHARGING GREEN
BLINKING
FULLY CHARGED GREEN
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
RED
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
RED
BLINKING
Incorrect Defect Note:
1. Put the battery pack into the charger.
• If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LED blinks GREEN, the battery pack is
good.
• If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LED shows blinks GREEN, the battery
pack is good.
• If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
7.2 CHARGING TIP
If you place 3 batteries on one side, they will charge faster
then putting them in different pockets.
7.3 EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6° C to 40° C (42.8° F to 104°
F) .
WARNING
If you attempt to charge the battery pack in a warm or hot
environment, and the charger LED light is red, remove the
battery pack and let the battery cool for approximately 30
minutes.
8 MAINTENANCE
8.1 CLEAN THE MACHINE
NOTE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or submerge in water.
• Clear the unwanted material out of the air vent with a
vacuum.
• Clean housing and the plastic components with a soft, dry
cloth.
IMPORTANT
Do not use strong solvents or detergents on the plastic
housing or components.
4
English
EN

9 TRANSPORTATION AND
STORAGE
9.1 MOVE THE MACHINE
• Move forward by the handle (1), or lift up the charger
by two handle grips (11).
9.2 STORE THE MACHINE
WARNING
Remove the battery pack before you store the charger or
disconnect the charger.
You can store the wheel charger horizontallly or vertically.
10 TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
SOLUTION
Charger doesn't
work. Charger
shows defective
mode. (LED
flashes Red)
Battery pack or
charger is defective
or there is a bad
connection be-
tween the battery
pack and charger.
Try to remove and
reinsert the battery
pack in the charg-
er.
Try charging a dif-
ferent battery
pack.
Unplug the charg-
er and wait until
the red LED goes
out, then reconnect
the plug to the
power supply.
Charger doesn't
work. Charger
shows evaluation
mode (LED indi-
cates Red solid
ON).
Battery pack is ei-
ther too hot, or too
cold.
Allow the battery
pack to reach nor-
mal temperature.
Charging will be-
gin when the bat-
tery pack returns
to 3°C-47°C
(37°F-117°F).
11 TECHNICAL DATA
Model 82CH62K
Voltage 82 V
Input 120V AC 50/60Hz, 15A Max
Output 82V DC 6A
5
English EN

12 LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, 2 year commercial battery
warranty against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners’ manual supplied with the product from new.
2 YEAR LIMITED BATTERY WARRANTY
COVERAGE:
– Greenworks Commercial Battery Packs (82BD250
82BD500, 82BD400, 82BD800 and other GL400BT or GL
300 series)
– 2 year from the date of purchase (non transferable)
WARRANTY EXCLUSIONS, LIMITATIONS AND
RIGHTS:
1. All warranties may not be transferred by the consumer to
any subsequent purchaser.
2. Parts or components not supplied by the warrantor, or
parts or components that have been modified.
3. Any failure resulting from the use of improper tools or
improper repair procedures.
4. Any failure resulting from the use of improper tools or
improper repair procedures.
5. Any failure or part that has become inoperative due to
accident, impact, abuse, misuse, neglect, mishandling,
dulling of cutting edges, or failure to operate the product
in accordance with the information provided in the
instruction manual supplied with the product.
6. Normal deterioration of the exterior due to use or
exposure, and any repairs made necessary by normal
wear, improper maintenance, improper lubrication,
improper storage, dirt, abrasives, impact, moisture, water,
rain, snow, rust, corrosion, varnish, or other similar
conditions.
7. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual.
8. Improper voltage for electric products and batteries that
have been exposed to temperatures beyond those
specified in the product’s instruction manual, batteries
that have not been properly charged or batteries that have
reached their useful life.
GREENWORKS HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-855-470-4267.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of the
purchaser. It is the purchaser’s responsibility to pay
transportation charges for any part submitted for replacement
under this warranty unless such return is requested in writing
by Greenworks.
Greenworks Tools
PO Box 1238
Mooresville, NC 28115
6
English
EN