Strongway 46440 User manual

300-Lb . Capacity Yard Cart
Owner’s Manual
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS
before operating. Failure to follow the safety rules and other basic safety precautions
may result in serious personal injury.
Item #46440

Page 1 of 6
Thank you very much for choosing a STRONGWAY product! For future reference, please complete the
owner’s record below:
Model: _________ Purchase Date: _________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to
become familiar with this product before you begin using it.
This cart is designed for certain applications only. The distributor cannot be responsible for issues arising
from modifications. We strongly recommend that this cart not be modified and/or used for any
application other than that for which it was designed. If you have any questions relative to a particular
application, DO NOT use the cart until you have first contacted the distributor to determine if it can or
should be performed on the product.
For technical questions please call 1-800-222-5381.
INTENDED USE
The Strongway 300-Lb. Capacity Yard Cart handles heavy loads up to 300 lb. and is perfect for hauling
patio blocks, firewood, gardening supplies, and much more. Slide the rear panel into the cart or pull-out from
the cart for easy loading and unloading.
TECHNICAL SPECIFICATIONS
Item
#46440
Capacity
300 lbs. (7 cubic feet)
Tires
22 in. spoked, pneumatic tires
Construction
Plywood
Production Dimensions
57 in. (L) x 32 in. (W) x 23 ½ in. (H)
GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed below
may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this cart until they have read this
manual and developed a thorough understanding of how the cart works.
WARNING: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover allpossibleconditions or situationsthat couldoccur. It mustbe understood by
the operator that common sense and caution are factors which cannot be built into this product, but
must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in injury.
2. Keep children away from work area. Do not allow children to handle this product.
3. Store idle equipment. When not in use, tools and equipment should be stored in a dry location to
inhibit rust.Always lock up tools and equipment, and keep out of reach of children.
4. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will do a
better job and more safely at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it was not intended.
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back
injury, etc.

Page 2 of 6
2
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
1. Do not modify the cart in any way. Unauthorized modification may impair the function and/or safety and
could affect the life of the equipment. There are specific applications for which the yard cart was designed.
2. Always check for damaged or worn out parts before using the cart. Broken parts will affect the cart’s
operation. Replace or repair damaged or worn parts immediately.
3. Do not at any time carry passengers, sit, or stand on the cart.
4. Do not exceed maximum load capacity of 300 lbs.
5. Avoid large holes and ditches when transporting loads.
6. Be careful when operating on steep grades; the cart may tip over.
7. Always use caution when loading and unloading the cart.
8. Always secure and lock the loads.
ASSEMBLY
Take all parts out of the shipping crate and inspect components to ensure there are no missing pieces
before starting to assemble the cart. Follow steps 1 through 4. Refer to the diagram and parts list.
Tool Required
Pliers
Screwdriver
Wrench
STEP 1 Attach the Wheels (Fig. 1)
1. Place the L-shaped frames on floor (2).
2. Insert the axle (3) through the holes on the L-shaped frames (2).
3. Slide the wheels (1) onto the axle (3), and then lock the wheels (1) with the washer (4) and lock pin (5).
Fig. 1

Page 3 of 6
3
STEP 2: Attach the Wood Floor Bed (Fig. 2)
1. Place the Wood Floor Bed (6) onto the L-Shaped Frame (2).
2. Attach the Wood Floor Bed (6), the L-Shaped Frame (2) and the Support Frame (7) together, tightening
with Bolt (8), (16) Washers (17), and Lock Nut (18).
3. Assemble the Rear Connect Bar (9) on the L-Shaped Frame (2) with a Lock Nut (18).
STEP 3: Attach Panels (Fig. 3)
1. Attach the Side Panel (11) and the L-Shaped Frame (2), tightening with Bolt (16), Washer (17), and Lock
Nut (18).
2. Attach the Side Panel (11), the L-Shaped Frame (2) and the Leg Support (13), tightening with a Bolt (10)
(12), Washer (17), and Lock Nut (18).
3. Slide the Rear Panel (14) into the cart.
Fig. 2
Fig. 3

Page 4 of 6
4
STEP 4: Attach Handle (Fig. 4 & Fig. 5)
1. Assemble the Handle (15) on the Side Panel (11), using a Bolt (12), Washer (17), and Lock Nut (18) to
tighten.
2. Tighten all bolts, washers, and nuts. The cart is ready for use.
OPERATION
WARNING: Before using the yard cart, review all safety information and the instructions below.
Failure to follow these instructions may result in property damage or injury to the operator or bystanders.
USING YOUR YARD CART
1. DO NOT exceed the rated capacity of 300 lb. (136kgs).
2. DO NOT over fill the cart.
3. ALWAYS use the cart for its intended purpose.
4. ALWAYS secure the loads when in use.
Fig. 4
Fig. 5

Page 5 of 6
5
MAINTENANCE
•Maintain your cart. It is recommended that the general condition of any cart be examined before it is
used. Keep your cart in good repair by adopting a program of conscientious repair and maintenance.
Have necessary repairs made by qualified service personnel.
•After each use, clean materials out of the cart box.
•Clean inside and outside of the cart after each use.
•Before operating, make sure the tires have the RECOMMENDED TIRE PRESSURE OF 40 PSI.
• Grease the axle and the wheel bearing area as needed.
•Periodically check all fasteners for tightness.
•Annually clean and lightly lubricate parts.
•Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
•Never exceed load capacity rating of 300 lb. (136kg).
STORAGE
•Never allow material to remain in the cart for extended periods of time.
•Before storing, make sure the cart is clean and dry. Proper storage will ensure years of trouble free
service.
•Store indoors or in a protected area during severe weather and winter months.
DIAGRAM AND PARTS LIST

Page 6 of 6
6
Part#
Description
Qty.
Part#
Description
Qty
1
Wheel
2
10
Bolt M6*50
2
2
L-Shaped Frame
2
11
Side Panel
2
3
Axle
1
12
Bolt M6*45
6
4
Washer 16
2
13
Leg Support
1
5
R Pin
2
14
Rear Panel
1
6
Wood Floor Bed
1
15
Handle
1
7
Support Frame
2
16
Bolt M6*25
8
8
Bolt M6*30
4
17
Washer 6
20
9
Rear Connect Bar
1
18
Nylon Lock Nut M6
21
For technical questions and replacement parts, please call 1-800-222-5381.
WARRANTY
One-year limited warranty
Distributed by
Northern Tool + Equipment Co., Inc.
Burnsville, Minnesota 55306-6936
www.NorthernTool.com
Made in China