Style selections SSR3472CLSV User manual

RETURN PANEL
ITEM #0954411, 0954409
MODEL #SSR3472CLSV, SSR3272CLSV
AB1809
NOTE: This product can only be installed along with the Frameless Door (Item #0954412,
0954410, sold separately). This item cannot be installed independently. When installing this
Return Panel, follow all of the instructions contained within this instruction manual FIRST,
then proceed to Step 6 of the Assembly Instructions section in the instruction manual for the
Frameless Door in order to complete assembly.
Serial Number
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Friday.
ATTACH YOUR RECEIPT HERE
Purchase Date
Français p. 9
Español p. 17

PART DESCRIPTION QUANTITY
L Return Panel 1
M Corner Gasket 1
PACKAGE CONTENTS
L
M

HARDWARE CONTENTS (Note: Hardware not shown to size)
Spacer
Qty. 2
TT
Wall Bracket
Qty. 1
UU
Wall Bracket Cover
Qty. 1
VV
Return Panel Bracket
Qty. 1
XX
3/4 in. Screw
Qty. 2
YY

SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
Safety glasses should be worn at all times during installation.
CAUTION
Two people are required to lift glass panel during installation. It is heavy and will break if dropped.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to assem-
ble the product.
Estimated Assembly Time: 90 minutes
Tools Required for Assembly (not included): Silicone caulk, caulk gun, drill, 1/4 in. drill bit, 1/8 in. drill
bit, measure tape, utility knife, level, pencil, Phillips screwdriver, handsaw, and safety glasses.

ASSEMBLY INSTRUCTIONS
Note: Instructions show right-side installation. Reverse for left-side installation. Instructions include
parts that are packed with Frameless Door (Item #095412, 0954410, sold separately).
1
A
2a
1. Set xed panel jamb (A) on shower base
threshold. Use a level to ensure panel jamb (A)
is level. Using a pencil (not included), mark the
four pre-drilled hole locations. Remove panel
jamb (A). Using a drill (not included), drill holes
approximately 1-1/2 in. deep into each marking.
NOTE: If installing into tile, use 1/4 in. masonry
bit (not included) and proceed to step 2a. If
installing into an acrylic or berglass shower
enclosure, use 1/8 in. drill bit (not included) and
proceed to step 2b.
BB
CC
A
2a. Tile installation: Insert wall anchors (CC) into
each drilled hole using rubber mallet (not
included). Place xed panel jamb (A) back into
place. Tighten 1-9/16 in. screws (BB) with
Phillips screwdriver (not included) into each
wall anchor (CC).
Hardware Used
Wall Anchor
1-9/16 in. Screw
CC
BB
x 4
x 4
2b BB
A
2b. Acrylic and berglass installation: Place
xed panel jamb (A) back into place. Tighten
1-9/16 in. screws (BB) with Phillips screwdriver
into each drilled hole.
Hardware Used
1-9/16 in. Screw
BB x 4