Summer FOLD AWAY User manual

08310D/19400B
4
LM
TO CLEAN:
Wash liner and frame with a soft cloth and mild soap.
Wipe liner and frame down with a dry cloth before storing.
TO STORE:
Step 1: Fold legs down by lifting each leg up and then folding inward.
Step 2: To fold tub, push bottom snap slightly up and across with thumb
as illustrated below (Figure K). Repeat for opposite side.
Step 3: Attach strap to post of frame (Figures L and M).
TO CLEAN & STORE:
K
INSTRUCTION MANUAL
FOLD AWAY
FULL-SIZE BABY BATH
Please read the following instructions
and warnings carefully.
Keep this instruction manual for future reference.
No tools required.
Adult assembly required.
For use with children from birth to 2 years
WARNING
Drowning Hazard: Babies have drowned while using infant bath tubs.
To prevent drowning:
• Stay in arm’s reach of your baby.
• Never rely on a toddler or preschooler to help your baby or alert you to trouble.
Babies have drowned even with other children in or near bath tub.
• Babies can drown in as little as 1 inch of water. Use as little water as possible to
bathe your baby. • Use in empty adult tub.
• Keep drain open in adult tub.
• NEVER bathe baby until you have tested the water temperature. ALWAYS check water
temperature before placing child into tub.
• Bath water should be between 90°F and 100°F (32.2°C and 37.8°C).
• Always check legs of tub to assure that they are securely locked in place prior to placing
child in tub.
• Always assure that the infant tub is completely expanded, flat and level in the adult bath tub.
• Never expand or collapse tub with child in it.
• This product is not a toy. DO NOT allow children to play with it.
• Make sure all pieces are properly assembled before placing infant in product.
• Never adjust product with infant inside the product. Remove infant before moving
or making adjustments.
Fall Hazard: Babies have suffered head injuries falling from infant bath tubs.
To prevent falls:
• Place product only in adult tub for safe use.
• Never lift or carry baby in tub.
• Never use on uneven or elevated surfaces.
• NEVER leave children unattended.
• Discontinue use of product if damaged, broken, or disassembled.
Please retain information
for future reference.
Colors and styles may vary.
MADE IN MEXICO WITH
IMPORTED COMPONENTS.
08/18
Summer Infant (USA), Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-401-671-6551
© 2018 Summer Infant, Inc.
We’re here to help! If you have questions or need assistance,
please contact our Consumer Relations Team at
1-401-671-6551 or www.summerinfant.com/contact

Liner
Legs
Bath Tub with Liner
FEATURES AND COMPONENTS:
2 3
SETUP:
B
A
Step 1: Unfold bath tub until locking snaps on underside of tub are fully
engaged (Figures A, B, and C).
Step 2: Unfold legs by rotating out and pressing down until fully snapped in.
Repeat for each leg (Figures D, E and F).
DEF
H
IJ
Step 3: To inflate liner, blow air with mouth into 2 locations noted (Figure G).
Note:You may need to squeeze the valve to inflate.
Step 4: Make sure drain plug is engaged and fill tub with 1” of water (Figure H).
To use in reclined position:
Step 5: Attach back strap to post on back of tub by reclining liner and securing
back strap over post of tub frame (Figures I and J).
Repeat on other side for newborns.
G
C
Locking Snap