Sunbeam FlexFit 900 User manual

FlexFit™ Heated Wrap
Almohadilla Térmica
Envoltoria FlexFit™
Instruction Manual
Manual de Instrucciones
Model / Modelo: 900
For product questions:
Sunbeam Consumer Service
USA: 1.800.435.1250
www.sunbeam.com
Para preguntas sobre el producto llame al:
Servicio de Atención al Cliente de Sunbeam Estados
Unidos: 1.800.435.1250
www.sunbeam.com
© 2019 Sunbeam Products, Inc. All rights reserved. Distributed by Sunbeam Products, Inc., Boca
Raton, Florida 33431. Sunbeam Products, Inc. is a subsidiary of Newell Brands Inc. (NYSE: NWL).
© 2019 Sunbeam Products, Inc. Todos los derechos reservados. Distribuido por Sunbeam Products,
Inc., Boca Raton, Florida 33431. Sunbeam Products, Inc. es una subsidiaria de Newell Brands Inc.
(NYSE: NWL).
FlexFit 900_19ESM2 (US) P.N. 196831 Rev A
Printed in China / Impreso en China GCDS-SUN476667-LD
FlexFit 900_19ESM2 (US).indd 2 2/14/19 10:22 AM

-1--2-
BETWEEN THE RED EDGES. BURNS MAY OCCUR.
8. BURNS CAN OCCUR REGARDLESS OF CONTROL
SETTING. CHECK SKIN UNDER PAD FREQUENTLY.
9. DO NOT USE IN AN OXYGEN ATMOSPHERE.
10. DO NOT USE PINS OR OTHER METALLIC MEANS TO
FASTEN THIS PAD IN PLACE.
11. DO NOT WRAP PAD TOO TIGHT AROUND THE BODY.
PAD SHOULD BE SNUG, BUT SHOULD NOT CUT OFF
CIRCULATION.
12. DO NOT WRAP PAD AROUND OR NEAR THE NECK
TO AVOID PERSONAL INJURY.
13. DO NOT SIT ON, AGAINST OR CRUSH PAD – AVOID
SHARP FOLDS. PLACE PAD ON TOP OF AND NOT
UNDER THE PART OF BODY NEEDING HEAT.
14. UNPLUG WHEN NOT IN USE. NEVER LEAVE
APPLIANCE UNATTENDED, ESPECIALLY IF
CHILDREN ARE PRESENT.
15. NEVER PULL THIS PAD BY THE SUPPLY CORD. DO
NOT USE THE CORD AS A HANDLE. DO NOT PINCH
CORD.
16. DO NOT TUCK IN, TRAP, FOLD, CROSS, PINCH, OR
WRAP CONTROL OR CORD WITH HEATING PAD
DURING USE.
17. USE CAUTION WITH PAD ENDS TO PREVENT HOOK
FASTENERS FROM DAMAGING CLOTHING OR OTHER
IMPORTANT SAFETY
INSTRUCTIONS.
DO NOT DESTROY.
DANGER: TO REDUCE THE RISK OF BURNS,
ELECTRIC SHOCK AND FIRE, THIS PRODUCT MUST
BE USED IN ACCORDANCE WITH THE FOLLOWING
INSTRUCTIONS:
1. READ ALL INSTRUCTIONS.
2. DO NOT USE WHILE SLEEPING.
3. DO NOT USE ON AN INFANT OR ON AN ANIMAL.
4. THIS PAD IS NOT TO BE USED ON OR BY AN
INVALID, SLEEPING, HELPLESS OR UNCONSCIOUS
PERSON, A PERSON WITH DIABETES, A
PERSON WITH POOR BLOOD CIRCULATION
OR INSENSITIVITY TO HEAT, OR A PERSON
INCAPACITATED BY MEDICATION.
5. THIS APPLIANCE IS NOT TO BE USED BY
CHILDREN. CLOSE SUPERVISION IS NECESSARY
WHEN ANY APPLIANCE IS USED NEAR CHILDREN.
CHILDREN SHOULD NOT PLAY WITH THE
APPLIANCE.
6. DO NOT USE ON AREAS OF INSENSITIVE SKIN.
7. DO NOT OVERLAP THE HEATED AREA LOCATED
FlexFit 900_19ESM2 (US).indd 1-2 2/14/19 10:22 AM

-3--4-
PROPERTY.
18. DO NOT PLACE ANYTHING OVER THE HEATING PAD
WHILE IN USE OR PLUGGED IN, SUCH AS A TOWEL,
BLANKET, CLOTHING, OR ANY OTHER INSULATING
MATERIAL, AND NEVER ALLOW HEATING PAD TO
WRAP AROUND ITSELF.
19. CAREFULLY EXAMINE PAD, COVER, CORD, AND
CONTROLLER BEFORE EACH USE. DISCARD THE
PAD IF ANY SIGN OF DETERIORATION, WEAR OR
DAMAGE. DO NOT TAMPER WITH THIS PAD IN ANY
WAY. THERE ARE NO USER SERVICABLE PARTS.
IF PAD DOES NOT FUNCTION SATISFACTORILY,
SEE WARRANTY FOR CUSTOMER CONTACT
INFORMATION.
20. LOOP CORD LOOSELY WHEN STORING, TIGHT
WRAPPING MAY DAMAGE CORD AND INTERNAL
PARTS. ALLOW TO COOL BEFORE STORING AND
DO NOT CREASE BY PLACING ITEMS ON TOP OF
IT. STORE IN THE ORIGINAL PACKAGING, IN COOL,
DARK, DRY PLACE.
21. IF PROVIDED WITH A DETACHABLE CONTROLLER,
USE ONLY WITH THE PROVIDED CONTROLLER.
22. USE THIS PAD ONLY AT RATED VOLTAGE,
AS MARKED ON THE PRODUCT. DO NOT USE
WITH GENERATORS, POWER CONVERTERS, OR
INVERTERS.
23. DO NOT USE THIS PAD WITH LINIMENT, SALVE OR
OINTMENT PREPERATIONS. SKIN BURNS COULD
RESULT.
24. THIS APPLIANCE IS NOT INTENDED FOR MEDICAL
USE IN HOSPITALS.
25. SAVE THESE INSTRUCTIONS.
HOUSEHOLD USE ONLY
POLARIZED PLUG
This appliance has a polarized plug,
(one blade is wider than the other). As
a safety feature to reduce the risk of
electrical shock, this plug is intended
to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do
not attempt to defeat this safety feature or modify
the plug in any way. If the plug fits loosely into the AC
outlet or if the AC outlet feels warm do not use that
outlet.
North American models with polarized plugs:
FlexFit 900_19ESM2 (US).indd 4 2/14/19 10:22 AM

-5--6-
WHERE TO USE YOUR HEATING PAD
Heating pads are effective pain relievers to soothe muscle and joint pain. The
FlexFit™ Heated Wrap has a long slim design with fastening ends that allow
you to wrap the heating pad to multiple areas of the body and secure the pad in
place for hands-free, targeted heat therapy.
This heating pad can be worn on several different areas of the body to
customize treatment. It is ideal for use on the upper and lower arm, wrist, lower
leg, and ankle.
Figure 1
Model: 900
HEATING PAD COMPONENTS HOW TO APPLY YOUR HEATING PAD
Note: Always consult with your physician
or health professional for recommended
treatment of an injury or chronic muscle or
joint pain.
1. Ensure the heating pad is connected to
the controller by making sure the cord
connector is securely attached to the pad
connector before using (Figure 3). Push
both parts together for a tight fit.
2. To wrap the heating pad, start at the top of
the pad where it indicates ‘start wrapping
here’ (Figure 1, number 5). Secure the first
hook fastener (Figure 1, number 3). This
is the end where the pad connects to the
controller.
3. Wrap the pad around the body and securely fasten the second hook
fastener directly to the exterior pad fabric. See figure 2 for the best way
to wrap each body part. NOTE: Be careful not to overlap the pad. The red
edges of the pad should never touch the pad (Figure 1, number 6).
4. Once in place, tighten each end around the body for a comfortable and snug
fit.
5. To remove pad, detach the hook fasteners tabs by pulling up on one end of
the pad. Unwrap pad from body.
NOTE: Some wear of the exterior pad fabric may be seen over time; this is
normal and will not affect the performance of the heating pad. Use caution
when fastening the pad to prevent hook fasteners from touching clothing.
Low Med
Auto-Off
2Hours
Hi
Select/ Off
1
2
4
5
6
3
1. Interior Pad Fabric
2. Exterior Pad Fabric
3. Hook Fastener
4. Controller
5. Top of the Pad
6. Red Edges
Arm Wrist Lower Leg Ankle
Figure 2
Low Med
Auto-Off
2Hours
Hi
Select/Off
Low Med
Auto-Off
2Hours
Hi
Select/Off
Auto-Off
2Hours
Select/Off
Low Med
Auto-Off
2Hours
Hi
Select/Off
A
B
A. Cord Connector
B. Pad Connector
Figure 3
FlexFit 900_19ESM2 (US).indd 5-6 2/14/19 10:22 AM

-7--8-
HOW TO USE YOUR HEATING PAD
1. After controller is connected to pad,
plug into 120V AC electrical outlet. Note:
Controller must be connected to heating
pad before plugging unit into outlet.
2. To turn the pad on, press the Control
Button (Figure 4, letter A).
3. Select from 3 heat settings: low, medium,
or high, by repeatedly pressing the control
button until the desired heat setting
indicator lights up (Figure 4, letter B).
It is recommended to start on the low heat
setting. Gradually move to the medium
and high heat settings in 15 minute
increments if more heat is desired. If at
any point during use, you feel discomfort,
select a lower heat setting or turn the unit
to the off setting. Check skin under pad frequently while using.
4. To turn the pad off, press the Control Button (Figure 4, letter A) repeatedly
until all of the heat setting indicator lights (Figure 4, letter B) turn off.
CAUTION:
• DO NOT SIT ON, LEAN AGAINST, CRUSH OR FOLD PAD DURING USE.
• DO NOT TO OVERLAP THE PAD. THE RED EDGES OF THE PAD SHOULD NEVER
TOUCH THE PAD (Figure 1, number 6).
• DO NOT USE WHILE SLEEPING.
• SEE ADDITIONAL WARNINGS IN THE IMPORTANT SAFETY INSTRUCTIONS
SECTION.
AUTO-OFF FEATURE
Your heating pad controller includes an Auto-Off feature. This feature is
designed to conserve energy by automatically turning off after 2 hours of
continuous use. The Auto-Off Indicator (Figure 4, letter C) will flash when the
auto-off feature is activated and the pad shuts off. To reset after Auto-Off, press
the control button until the desired heat setting is reached.
NOTE: After a power outage, the Auto-Off feature automatically resets the time.
HOW TO USE YOUR HEATING PAD WITH MOIST
HEAT THERAPY
In some cases, you may find that moist heat therapy
provides more comfort and relief. When using moist
heat therapy, you should protect furniture and
clothing from becoming damp.
1. Dampen the interior pad fabric (Figure 1, number
1) of the heating pad with water by patting the
surface with a wet sponge or cloth, or use a spray
bottle to apply a fine mist. Do not thoroughly soak
pad.
2. Do not spray or dampen the pad connector
(Figure 5).
DANGER: DO NOT IMMERSE THE PAD OR WIRING IN
WATER OR PLACE UNDER RUNNING WATER. FAILURE
TO COMPLY MAY RESULT IN PRODUCT FAILURE
AND/OR PERSONAL INJURY. THE ELECTRICAL PAD
CONNECTOR MUST BE THOROUGHLY DRY BEFORE
ESTABLISHING ELECTRICAL CONNECTION.
WASHING INSTRUCTIONS
DO NOT DRY CLEAN! DO NOT USE BLEACH! DO NOT USE WRINGER!
1. Disconnect pad from outlet. DO NOT PULL BY THE CORD.
2. Disconnect controller cord from pad by holding the pad side connector with
one hand and pulling firmly on the cord side connector with the other hand.
3. Fold pad ends and attach hook fasteners to the exterior pad fabric before
placing in the washing machine, or separate in a laundry wash bag.
4. Machine wash pad in cold water on gentle cycle or hand wash. Tumble dry
on low heat and remove promptly from dryer or drape to dry.
5. DO NOT plug in pad and pad connector until completely dry.
6. For information on service, visit our website at www.sunbeam.com.
Low Med
Auto-Off
2 Hours
Hi
Select / Off
Figure 4
A. Control Button
B. Heat Setting Indicator
C. Auto-Off Indicator
Figure 5
FlexFit 900_19ESM2 (US).indd 7-8 2/14/19 10:22 AM