Sunrise Medical IC-6623 User manual

Guardian®Full-Length, Clamp-on Telescoping Rails
User Instructions
Model IC-6623
RISK OF SERIOUS INJURY. When using side rails, only use side rails that can be
ositioned so that the ga between the side rails is large enough that the trunk
and hi s can easily ass through it. Make sure when raising the bed, head sec-
tion or foot section does not create any of the reviously described ga s.
RISK OF SERIOUS INJURY OR DEATH. If side rail is used, follow guidelines in
rail User's Manual. Use of side rail can ex ose atient to risk of suffocation
if head becomes tra ed between mattress and side rail.
POSSIBLE INJURY. Make sure side rails are secured ro erly before using bed.
RISK OF SERIOUS INJURY. Individuals with hysical limitations who cannot
revent themselves from rolling or climbing out of the bed may require other
means of safe ositioning.
POSSIBLE DAMAGE OR INJURY. Do not use the side rails as handles when
moving the bed.
POSSIBLE DAMAGE OR INJURY. Side rails do not fall within any weight limita-
tions and may be damaged if excessive ressure is laced on them. Side rails
are for the ur ose of aiding in turning and re ositioning within the bed and
are not intended to be used for restraint ur oses.

ASSEMBLY INSTRUCTIONS (FIGURE 1)
1. Remove the mattress from the bed.
2. Place the bed in the flat position.
3. Measure the width of the bed frame. ttach the two crossbrace assemblies
together.
4. Place the assembled crossbrace on the bed frame. ttach clamps as shown and
tighten wing nuts until secure. Prevent the lock nut from contacting the bed
frame.
5. Once the crossbrace is adjusted properly, tighten the center bolts and nuts.
6. Repeat steps 3-5 for other crossbrace. Ensure the other crossbrace is between
62" to 64" apart as shown.
7. The slide tube can be rotated with the locking knob on the right or left by
rotating the slide. The bed rail can be adjusted higher or lower based on your
rail height preference.
8. Insert the rail into the slide tubes. Pull the plunger knob to adjust the rail
height.
RISK OF SERIOUS INJURY OR DEATH. When using side rails, use a mattress thick
enough and wide enough so that the ga between the to of the mattress and
the bottom of the side rails and the ga between the side of the mattress and
the side rails is small enough to revent a atient from getting his or her head
or neck between the mattress and the side rail. Assure that articulating the
bed, head section or foot section does not create any hazardous ga s. Failure
to do so could result in injury or ossible suffocation.
RISK OF SERIOUS INJURY OR DEATH. When using side rails, only use side rails
that can be ositioned so that the ga between the headboard or foot board
and the side rails is small enough to revent a atient from getting his or
her head or neck between the mattress and the side rail or large enough that
the trunk and hi s can easily ass through it. Assure that articulating the
bed, head section or foot section does not create any hazardous ga s. Failure
to do so could result in injury or ossible suffocation.
RISK OF SERIOUS INJURY OR DEATH. When using side rails, only use side rails
in which any ga s between the rail body members are small enough to revent
a atient from getting his or her head or neck inside the rail body. Failure to
do so could result in injury or ossible suffocation.
RISK OF SERIOUS INJURY. When using multi le side rails on one or both
sides of the bed, only use side rails that can be ositioned so that the ga
between the side rails is large enough that the trunk and hi s can easily
ass through it. Assure that articulating the bed head section or foot section
does not create any hazardous ga s.
Figure 1
Slide Tube
Wing
Nuts
Center Bolts
Plunger Knob

OPERATING INSTRUCTIONS (FIGURE 2)
1. Hold the rail securely, then pull the plunger knob.
2. Lower or raise the rail to desired height, then release the knob until the rail
locks into the appropriate rail adjusting hole.
3. Ensure that head-end and foot-end of bed rails are adjusted to the same height
prior to use.
© 2002 Sunrise Medical 7.02
IM-429009 Rev.
Manufactured for:
Sunrise Medical, Inc.
7477 East Dry Creek Parkway
Longmont, Colorado 80503
Printed in Taiwan
www.sunrisemedical.com
Phone: [phone]
Toll Free Phone: [phone]
In Canada: [phone]
Figure 2
Plunger Knob