ENG
4
Remote control
aSTANDBY: STANDBY button
bSUB+/–: subwoofer volume control buttons
cPC: PC turn on button
dTV: TV turn on button
eLEFT BAL+/RIGHT BAL+: balance control buttons
between left and right channels
fRESET: return button to factory settings
gMUTE: MUTE button
hTREBLE+/–: treble level control buttons
iAUX-: AUX turn on button
jVOL+/–: volume control buttons
Remote control battery installation
• Open battery compartment on the back of
remote control.
• Input AAA type batteries (included), sticking to polarity.
• Close the battery compartment.
Notes:
• Use remote control at an angle not more than 30° at
a distance not more than 7 meters.
• Direct remote control at the IR receiver display on
subwoofer.
• If remote control does not work, check the batteries
or replace the discharged batteries for new one.
• Remove the battery from remote control, unless
you intend to use it for a long time (more than a week).
• Keep remote control in a clean, dry place.
5. PREPARATION AND OPERATION
Speaker placement
•Place the speakers symmetrically to the listener at the distance not less than one meter. The
subwoofer emits non-directional sound, therefore it can be located in any place of the room, where
it will sound to the best advantage.
•Place MSS far away from monitors and TV sets, as insignificant image distortion in these super-
sensitive devices is possible.
MSS сonnecting and control
MS-370 Multimedia Speaker System can be connected to virtually any audio source: DVD/CD, PC,
laptop, etc. (see connection diagram in Fig. 4).
•Before connecting make sure that MSS is switched off. Then connect subwoofer AUDIO OUTPUT
jacks mwith satellite by using audio cables (included) (see diagram in Fig. 4), sticking to polarity.
• To connect MSS to TV, DVD/CD-players, 2RCA to 2RCA stereo signal cable (included) should be
used, as shown in Fig. 4.
Fig. 3. Remote control
TREBLE
STANDBY MUTE
VOL
VOL
-
+
SUB
TV PC AUX
RESET
MS-370
REMOTE CONTROL
LEFT
BAL +
RIGHT
BAL +
ag
b
d
c
e
f
h
i
j
e
j
2.1 Multimedia Speaker System
