SWAG V4.0 User manual

WWW.SWAGOFFROAD.COM
“DOING ORDINARY EXTRAORDINARY”
SWAG Portaband Table V4.0 Installation
Instructions
1) Install bolt on side legs:
Attach the bolt on side legs using the supplied 5/16” bolts
and nuts.
2) Hardware Kit Assembly:
Using the supplied 5/32” hex key and a ½” wrench, install the 5/16” jam nut so it is
flush with the bottom of the 5/16” set screw.
3)Set Screw Installation:
Install the 7/8” long set screw from the bottom of the table so the top of the fastener
protrudes through the top of the table ~3/16”.

WWW.SWAGOFFROAD.COM
“DOING ORDINARY EXTRAORDINARY”
4) Blade Guard:
Push the button on the side of the blade guard (red arrow shown above) to extend the
guard in the in the farthest outward position as shown in the 2nd picture above.
5) Saw Installation:
Install the saw into the portaband table, so the table slides into the air vent of the saw.
Then install the provided 5/16” washer on to the thumb knob. Hand tighten the thumb
knob from the bottom of the table so it goes through the middle of the blade guard.
6) Blade Alignment:
Using the supplied 5/32” hex key,
tighten the set screw down until the
blade is perpendicular to the top
working surface of the portaband
table.
Note: If the set screw sticks up past
the top of the table, it will need to be
removed then the bottom of screw
will need to be ground down and
reinstalled.

WWW.SWAGOFFROAD.COM
“DOING ORDINARY EXTRAORDINARY”
7) Trigger Control.
We recommend using an 8” Velcro strap or a 2.5” spring clamp to hold down the
trigger on the saw. These options can easily be removed when the saw is not
mounted in the SWAG Portaband table.
8) Hex Key Retention.
We have found a great place to store the 5/32” hex key, place it inside the power
chord rubber boot show below. Regardless of how you store this key it will be needed
to remove your saw from the table. The same hex key can be used to adjust the bolt
on miter gauge rails if they come loose or have rotated during shipping.