Battery Cover
4 x 1.5V ‘AA’
Batteries
Charging helicopter: pull open the door of the charge-wire storage compartment, which is located
on the back left side of the remote controller. Take out charge-wire and plug into the bottom of the
helicopter charge port. Be sure the helicopter switch is turned off and the remote control is turned
on. When charge is completed, the charge light on the remote controller will go from red to blue.
Please allow up to 60 minutes for a full charge.
FLYING YOUR HELICOPTER
Charge time: up to 60 minutes - Flight time: up to 8 minutes
Fresh alkaline batteries strongly recommended
REMOTE CONTROL
THROTTLES
Select band ‘A’ or ‘B’ by pressing band selector button down for 3 seconds (see pg.3).
Turn power switches for helicopter and R/C to ‘ON’- lights will turn on.
Point top of controller towards helicopter and step back 6-8 feet. ( 1.8-2.4 meters )
For best signal strength, always keep the top of the R/C pointed towards the helicopter.
Turn safety off by moving left throttle up / down. You are now ready to start flying!
PARTS - SERVICE - REPAIRS ... www.extremercbyrsi.com or Call our MI Service Center: 586-757-1336 x 1
Unscrew and remove battery cover
from R/C unit, insert 4 ‘AA’ batteries,
noting polarity indicators. Replace
battery cover.
Charge-Port
Plug charge-wire into
charge-port
WHEN CHARGING, BE SURE TO TURN THE SWITCH ON THE HELICOPTER TO ‘OFF’
Take out Charge-Wire
Charge-Wire
ON/OFF Switch
Turn OFF helicopter
Turn ON Remote Control
1 3
42
Charging Helicopter