Syris SYRDF5 User manual

Install and Operation
Instructions
SYRDF5 Fingerprint Reader
SYRIS Technology Corp.
ADD : 21F-2, No. 12, Sec. 1, Taijunggang Rd.
Taichung, Taiwan (403)
TEL : [phone]
FAX : [phone]
E-Mail : [email protected]
Website : http://www.syris.com
May 25, 2004 Ver:2.00
WiegandTM &RS485DUALINTERFACE

SYRDF5 WIRING DIAGRAM
* Power supply should be regulated linear power supply.
* Your system must have a single earth ground point.
* The shield must run continuous throughout the installation.

SYRDF5 MOUNTING PLATE
SYRDF5 Specification
Items / Specs SYRDF5
Number of fingerprint 1,000
Fingerprint sensor capacitive sensor in CMOS technology
224x288 pixels （513dpi）；data format；8bit/pixel
ESD protection2；15kV air discharge on the sensor surface
Mechanical resistance；hard surface provides protection against
Chemical resistance；Enhanced resistance against most liquids,gasses,sweat
Card (Transponder) 125KHz,TEMIC/EM compatible （Option 13.56MHz Mifare 1）
Read range* 3cm~12cm
Card read time 0.2sec(typical)
Indicator 3LED
Input Points 4 voltage free
Control relay output 2 relay output
Output interface RS485 formats and WiegandTM formats
WiegandTM formats WiegandTM 26 bits、34 bits、42 bits formats
Baud rate 19,200 bps (4,800、9,600、19,200、38,400、57,600、115,200、230,400)
Color Beige or Gray
Operating temperature 2 ℃to 55 ℃
Storage temperature -30 ℃ to 70 ℃
Power supply input 8V to 20V DC
Dimensions (mm) 83.0 W x 121.0 H x 42.2 D
* This specification is preliminary and is subject to change without prior notice
* Reading range is subject to card type, site interference and antenna specs for more information