Tarter CattleMaster 120 User manual

CattleMaster®
120 Open Sweep
& Alley System

Sweep System Set Up Diagram
LEFT HAND - OUTSIDE CONTROLS
T
HIS KIT
WILL MAKE ANY OF THE SIX CONFIGURATIONS SHOWN BELOW.
AREA REQUIRED 15' x 31' 6" FOR THE 90 DEGREE UNITS
LEFT HAND - INSIDE CONTROLS
STRAIGHT LEAD-IN UNITS - RIGHT OR LEFT HAND - INSIDE CONTROLS - AREA REQUIRED IS 11' 3" X 31' 10"
120 OPEN SWEEP SYSTEM KIT - ITEM # OSS120
ESTIMATED SHIPPING WEIGHT 1680 LBS.
RIGHT HAND - INSIDE CONTROLS
ADJUSTABLE ALLEYWAY ARCH (ONE WAY) - ITEM # AAA1
ADJUSTABLE ALLEY ARCH (TWO WAY) - ITEM#AAA2
CENTER ARCH ASSEMBLY - ITEM # CAA
SWEEP GATE LATCH - ITEM # SGL
AT TACHMENT RODS (3) - ITEM # AR
STRAIGHT 10' ALLEY PANELS (4) - ITEM # SAP10
STRAIGHT 10' PANEL WITH ARCH - ITEM # SAPA10
SWEEP PEN GATE - ITEM # SPG
RIGHT HAND - OUTSIDE CONTROLS
CURVED SWEEP PANEL - ITEM # CSP

STEP TWO
STEP ONE
120 ANGLED TUB ALLEY AND SWEEP
STEP FOUR
STEP THREE
STEP FIVE
Attach the first bow
to Palpation cage,
CattleMaster®chute
or your existing chute
using attachment
rods. Note that the
first bow has corral
hardware on one side.
Attach two 10’ straight
alley panels to back of
first bow.
Attach the second
bow, making sure that
adjustment handles
remain on the same
side. This bow has
drop-pin connectors
on both sides.
Attach the
two remaining
10’ straight
alley panels
to the second
bow.
Attach the sweep
exit panel with
arch assembly.
This panel may
be oriented for
right- or left-hand
sweep.
assembly instructions
OSS120

WWW.TARTERUSA.COM
STEP SEVEN
STEP NINE
ROUND ‘EM UP! HEAD ‘EM IN!
STEP SIX
STEP EIGHT
Attach main
sweep bow,
which contains
sweep gate and
the secondary
bow, to end of
sweep exit panel.
Spread out
secondary
bow.
Attach first curved
panel to sweep
exit panel with
arch assembly and
secondary bow and
lock with pins.
Attach second
curved panel to
secondary bow and
main sweep bow
and lock with pins.
NOTE: Depending on the direction of the sweep, you may
need to unbolt sweep gate latch assembly and mount to
opposite side of sweep gate. Also the secondary arch will
need to be moved to the other side of the main sweep arch
according to which direction you are setting the system up.
PART #4000011