TE Connectivity NanoMQS 2280687-1 User manual

Instruction Sheet
1 of 2
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
408-32201
12 OCT 15 Rev A
Figure 1
1. INTRODUCTION
This instruction sheet describes the use of Extraction Tool 2280687-1. This tool is designed to remove
NanoMQS contacts (1703930-[ ] and 2272196-[ ] from NanoMQS plug assemblies.
Read these instructions thoroughly before attempting to remove any contacts.
NOTE
All dimensions are in millimeters [followed by inches in brackets]. Figures and illustrations are for reference only and are not
drawn to scale.
2. DESCRIPTION
Each tool features a handle marked with the specific part number and a contact lance release tip. The contact
lance release tip depresses the contact locking lance to allow extraction of the contact.
3. EXTRACTION PROCEDURE
These steps are recommended: see Figure 2.
1. Orient the tool as shown with respect to the connector and wire being extracted.
2. Insert tool tip into BACK of lance cavity until tool stops. The tip of the tool will bottom in the back of the
housing. See detail for correct placement.
3. Holding tool in position, grip wire and pull contact out of housing.
4. Remove tool from housing.
5. Repeat as required.
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Extraction Tool
NanoMQS 2280687-1
Lance Release Tip
Tool Part
Number
NanoMQS Connector
Extraction Tool
ORIGINAL INSTRUCTIONS

408-32201
Rev A
2 of 2
Figure 2
4. TOOL INSPECTION/MAINTENANCE
It is recommended that each tool be inspected upon its arrival to be sure it has not been damaged in transit,
and at regularly scheduled intervals to be sure it remains functional.
5. REVISION SUMMARY
Initial release of document