Tebco Discovery 2019 User manual

Discovery and Explorer 2019 Assembly Instructions
Open the box. Remove any loose items (parts box
and manual).
Carefully lift out of the box and place on a hard,
flat, clean workspace.
The pedals, charger and head stem crown are
located inside the parts box.
Look for the quick release axle when unpacking the
bicycle –this is cable tied to the wheel.
All manuals and user guides at all-guides.com

Insert the head stem into the head tube. The head
stem can be raised or lowered to suit riders
comfort. Make sure to place the head stem crown
in the correct position before doing this.
Tighten the head stem with a 6 mm allen key. You
can adjust the angle of the head stem with the
6mm allen key on the side if desired too.
Adjust the handlebar head cap such that the
handlebars are at the desired riding angle for riders
comfort.
Attach front mudguard to fork bridge using bolt
supplied. This bolt also holds the front headlight.
Be sure to leave adequate tyre –mudguard
clearance. This requires a 5 mm allen key.
All manuals and user guides at all-guides.com

Attach the remaining two screws that hold the
mudguard and ensure they are tight. These are
attached using a 4 mm allen key. NOTE: Mount
these on the mounting points halfway up the side of the
fork to avoid clearance issues with the disc brake
assembly.
Insert quick release spindle into the front hub and
adjust in readiness to insert into fork.
Insert into fork and tighten –this must be tight, but
do not overtighten. An experienced bicycle
mechanic is your best friend here.
Attach both the LEFT and RIGHT pedals using a
15 mm open end / pedal spanner. NOTE: These
are threaded differently and labelled on the end of
the thread as L or R.
Locate the keys which will be hanging from the
cables on the front of the bike.
The battery can be removed by inserting the key
into the lock and twisting clockwise. The battery will
then pop out. Simply pop back in and push to re-
insert battery. It will lock automatically.
All manuals and user guides at all-guides.com

The battery can be recharged whilst in the bike by
exposing the charging port under the flap just at
the top of the battery casing. The battery charger
will show RED whilst charging and green when
charged.
Pump up the tyres to between 40 –65 PSI (280 –
460 kPa). 60 PSI (413 kPa) is perfect!
To turn the bike ON or OFF, hold the power button
on the control panel for two (2) seconds. When the
bike is powered on, the indicator panel will be
backlight and display information.
PAS settings can be adjusted with the UP (+) and
DOWN (-) buttons. The headlight and taillight can
be adjusted with the light button. Consult the user
manual for more detailed information.
All manuals and user guides at all-guides.com

Your new Discovery (pictured) or Explorer will now look like this and is ready to ride.
For optimum performance and durability of your Discovery or Explorer we strongly suggest you have your
new Discovery or Explorer assembled, thoroughly checked and adjusted by an experienced qualified
Bicycle Technician.
All manuals and user guides at all-guides.com