Techni Mobili RTA-8050 User manual

PARTS LIST
ATTENTION: Before you begin to assemble the product, please make
sure that all the parts are included in the package, and
inspect them for damages or defects.
(A)x1
Backrest
(B)x1
Seat
(C)x1
Base
(D)x1
Mechanism
(E)x1
Gas Lift
(F)x5
Casters
(G)
1 Right, 1 Left
ARMS
(H)x4
Screws M6x25mm
(J)x4
Screws M6x35mm
Washer
(I)x4
Screws M6x20mm
(K)x4
Cap Cover
(L)x1
Allen key
®
ASSEMBLY INSTRUCTIONS CHAIR STYLE RTA-8050
C
E
F
Insert all the casters(F)
into the base (C) using
pressure, then place
the gas lift (E) in the
middle of the base (C).
A
G
Assemble the arms (G)
to the backrest (A) on
their respective sides
using screws (H) and
cover the holes with
caps (K).
K
H
Assemble the arms (G) to
the seat (B) using screws
and washers (J) as
shown.
L
B
G
A
J
A
G
B
D
I
ATTENTION:
- To avoid misalignments, leave the screws
loose and do not tighten them until all are
in place.
- Do not overtighten or force the screws as they
could break or strip.
- Using the wrong size of screws on a part might
cause damage to it.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Install the mechanism (D)
under the seat B and
attach it with screws (I).
Make sure the tension
knob is facing towards the
front of the seat and the
lever/handle is on the
right side of the chair.
Place the top parts of the
chair over the base parts
making sure the gas lift
enters into the center
hole of the mechanism.
The top and base parts
will stay together by
pressure after seating.

®
- To raise or lower the chair’s height: Pull the handle UP with force. The chair
will go down while sitting on it, or up if you lift your body.
- Tilting mechanism: Pull the handle OUT (horizontally) to unlock and IN to lock.
- Tilt tension control: Turn the mechanism’s knob either direction to apply more
or less tension to the tilting function.
LIFT AND TILT FUNCTIONS:
WARNINGS:
- Do not stand up on the chair.
- Do not use the chair as a ladder.
- Use for seating only one person at a time.
- At least every 4 months, check all bolts, screws and knobs to be sure they
are tight. Do not use if parts are loose, damaged or missing.
- Failure to follow the above warnings could result in serious injury.
- Do not apply solvents or polishers directly to the chair parts. Instead, use a
clean soft damp towel with a solution of mild soap and water.