Techni Mobili RTA-1006 User manual

M6x22mm, x4
ASSEMBLY INSTRUCTIONS FOR CHAIR MODEL
RTA-1006
PARTS LIST
ATTENTION: Before you begin the assembly,
make sure that all parts are included in good
condition.
ATTENTION:
⚠Follow the in truction tep by tep.
⚠To avoid mi alignment , leave the crew loo e and do not tighten them until all are in their re pective place .
⚠Do not overtighten or force the crew a they could break, trip, or damage the thread of the hole .
E
D
C
A
B
F
ASeat, x1
BMechanism, x1
D
E
ydraulic
Gas Lift, x1
F
CStar Base, x1
Caster, x5
In ert the ca ter (E) into the leg of the ba e (C) u ing
pre ure, then place the ga lift (D) in the middle of the ba e
a hown.
Place the eat (A) up ide-down with it backre t end toward
you a hown. U ing crew (F), a emble the mechani m (B)
to the eat with it handle facing to your LEFT a hown.
Place the eat over the ba e, making ure the tip of the ga
lift enter into the hole of the mechani m.
(Mechanism)
Allen Wrench, x1
Before itting on the chair for the very fir t time,
make ure that the crew are tighten well.
G

To raise or lower the chair’s height, pull UP the lever that is under the seat.
The chair goes down while sitting on it, or up if you lift your body.
NOTE: This chair does not recline.
WARNINGS:
•Do not stand up on the chair or use it as ladder.
•Use the chair to seat only one person at a time.
•Do not use the chair if parts are damaged or if screws are loose or missing.
•Do not seat near the edge of the seat and always sit properly on the chair to avoid going beyond your balance point and fall off the chair.
•The chair is intended for teenagers and adults. If small children are using the chair, please keep close observation on them.
•Do not allow small children to play with the chair.
•Not paying attention to these warnings could result in severe injuries.
CARE AND MAINTENANCE:
•To clean the chair it is recommended to use a soft cloth lightly damped in a solution of smooth soap and water, then dry with a clean
towel.
•Do not use solvents or abrasive materials to clean any part of the chair.
•Before applying a cleaning agent, test on a small hidden area of the chair, like underneath the seat.
•Do not expose the product to direct sunlight or to extreme environmental conditions.
•Every 4 months, inspect the chair completely and make sure that all screws are tighten.