Teka IR 321.1 User manual

INSTALLATION INSTRUCTIONS
AND RECOMMENDATIONS FOR USE AND MAINTENANCE
INDUCTION HOB
IR 321.1

Disposing of the device
When disposing of the device,do not bring it to regular
municipal waste containers.Instead, bring it to electrical
and electronic waste recycling and reuse center. A relevant label has
been put on the device, its instructions manual, or the package.
The device has been manufactured of recyclable material. by
bringing old device to recycling collection center, you show that you
care about nature.
Ask your local environmental care authority for information on
location of such facilities.

WARNING..................................................................................................1-2
INSTALLATION.............................................................................................3
1.CUTTING THE CUPBOARD.............................................................3
2.PLACE OF INSTALLATION...............................................................4
3.PREPARING THE HOTPLATE..........................................................5
4.ELECTRICAL CONNECTION...........................................................5
WHAT’S SPECIAL ABOUT INDUCTION COOKING ?.................................6
1.POWER AND SAVINGS....................................................................6
2.SAFETY.............................................................................................6
3.CLEANING........................................................................................7
FUNCTIONING.............................................................................................8
1.DESCRIPTION OF THE HOB...........................................................8
2.USING THE TOUCH CONTROL.......................................................8
3.TIMER FUNCTION ...........................................................................9
4.PAN .................................................................................................10
WHAT SHOULD I DO IF.............................................................................11
TECHNICAL DETAILS ...............................................................................12
CONTENTS

WARNING
•In case of failure,only the Authorised Technical
Service may repare this hob. Otherwise the
guarantee will be null and void.
•The technical and identification data for the hob
figure on the reference plate fixed to the appliance.
•This refernence plate must be consulted before
making the electrical connections.
•The electrical connections must be made by a
specialist aware to the legal and regulatory,
requirtements in each country.
•Fill in table on the front cover with the data from the
appliance referance plate.
•This appliances is not intended for use by persons
(including children) with reduced physical.Sensory or
mental capabilities,or lack of experience and
knowledge,unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
•Children should be supervised to ensure that they do
not play with the appliance.
WARNING: if the surface is cracked,switch off the
appliance to avoid the possibility of electric shock.
•Metallic objects such as knives,forks,spoons and lids
should not be place on the hob surface since they can
get hot.
•The appliance is not intended to be operated by
means of an external timer or separate remote-
control sysetm.
1

2
WARNING:The appliance and its accessible parts
become hot during use. Care should be taken to
avoid touching heating elements.
Children less than 8 years of age shall be kept
away unless continuously supervised.
--The appliance can be used by children aged
from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved.
--Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
--The instruction for ovens shall include the
substance of the following:
WARNING: Accessible parts may become hot
during use. Young children should be kept away.

IMPORTANT
There must be a minimum distance of 100 mm between the hole and the
wall or adjoining cupboard.If the hob is more than 30 mm thick,or if it is
placed on a false top,the ventilation cover must be fitted as shown in the
figure below.
1CUTTING THE CUPBOARD
INSTALLATION
3
100mm
65mm
FITTING DIMENSIONS
induction Hobs
min 38
520
288
70
270
490

2PLACE OF INSTALLATION
ABOVE A DRAWER
The electronic circuits of
the induction hob must
be cooled by a current of
fresh air as shown in the
diagram,and the points
below must be carefully
complied with.The
greater the distance
between the hob and the
cupboard underneath
it,the better the hob will
function.
IMPORTANT
Your induction hob needs an air inlet at the rear and an air outlet at the front.
ABOVE A CUPBOARD WITH DOOR
When the air outlet is underneath the hob:
ldeally, an air outlet grille should be
placed between the hotplate and the
cuboard door.It will be easy to install if the
cross bar is small.
If the cross bar is rectangular or the
hotplate is closed off,make a bevelled cut
to free the air outlet.
4
b
a
4.7cm min
SANITARIO
9.5cm
10mm min
45°

ABOVE A OVEN
The hotplate may be flush-mounted above
an oven of the same brand.
This oven has an upper ventilation system
and can therefore be installed in a high
position.
To do this ,remove the front cross bar of the
cupboard to leave a minimum space of 5 mm
free
IMPORTANT
Your induction hob must NOT be installed
above a dishwasher, washing
machine,refrigerator or freezer
3PREPARING THE HOTPLATE
Remove the adhesive paper and stick the seal provided with the
appliance all around the hob.
l220-240V monophase
hok-up~ -
4ELECTRICAL CONNECTION
The vitro-ceramic hob is supplied with a power cable.
If the cable is damaged in any way it must be replaced by the manufacturer or after-
sale service or by authorised technical staff, to avoid hazard.
If the mains supply where the hob is to be installed is different from 220...240V~,make
the connection as shown in the enclosed diagrams.(The cable must be able to
o
withstand temperatures of 90 )
It must be connected to the mains at a socket complying with EEC publication 7 or a
single-pole cut-off device with a contact opening distance of at least 3 mm.
Nominal power
per phase Protection
15.6A 20A
IBB-30GT4FG
HOB Voltage
222222000.........222444000VVV
Total power
Technology date
5
Brown
Blue
Green/yellow
Neutral
Phase
Earth
L
N
3.0 KW
40mm min
2
40cm min
5mm min
Oven in high position

6
The risk of burns from the hot glass is minimal. As the heat is produced in the
pan itself,the glass hardly heats up at all.
The induction rings have a pan detection system,i.e.the ring will not work
unless there is a suitable pan on it.
,
WHAT S SPECIAL ABOUT INDUCTION COOKING
Induction hobs heat up food much more quickly than other systems do.
As the heat is produced in the pan itself, much less energy is lost and performance
is much better. Induction cooking uses up only half as much energy as other
systems.
This lower consumption makes induction cooking the cheapest of all the electric
cooking systems. It is almost as economical to use as a glass hob.
2SAFETY
1POWER AND SAVINGS
heats up
bolling water
temperature
of glass
induction radiant vitro-
ceramic or
halogen
100
200
300
400
500
81℃
420℃
does not heat up
IMPRORANT
TO THE ATTENTION OF CARDIAC PACEMAKER AND ACTIVE IMPLANT USERS:
The hotplate complies with the current electronmagnetic interference regulations.
This induction hob fully complies with all legal requirements (EEC directives
89/336).It is designed not to interfere with the functioning of other electrical
appliances.providing they comply with the same regulation.
THIS INDUCTION HOB GENERATES MAGNETIC FIELDS IN ITS IMMEDIATE
SURROUNDINGS.
Your pacemaker must be designed in compliance with the corresponding regulations
in order for no interference to be caused between it and the hotplate.Consult the
pacemaker manufacturer or your doctor to determine whether it complies with the
regulations in force or whether any incompatibilities exist.

induction
kitchen paper
vitro
cleaner
cloth
3CLEANING
Spills and splashes will not harden and stick to the glass,as it hardly heats up.
Both Vitro-ceramic and induction rings should however be cleaned of any spills or
splashes as quickly as possible.
Slight stains can be removed with kitchen paper or cloth.
More resistant stains will need specific product for vitro-ceramic glass. Follow each
product’s inductions.
IMPORTANT
Do not use abrasive products or cleaning powders as these could scratch the hob.
Do not use a steam cleaner.
If any cracks should appear on the surface of the glass,unplug he appliance
immediately.Do not use any part of the hob untill a new vitro-ceramic glass has been
installed.
7