Teledyne BlueView M Series User manual

Quick Start Guide
M-Series Sonars (incl. Mk2)
Doc. No. QG21283 / Part No. 1015281 July 2020
Install ProViewer Software
Insert the USB key.
Run Setup.
If prompted, click “Do not block”.
Configure your PC network interface card
Set your PC Network IP address to 192.168.1.3
Set the Net Mask to 255.255.255.0
Bench Test the Sonar
Connect the sonar as shown here.
(The various components may differ in appearance.)
Connect the sonar cable to the SONAR J1 port
on the POE box.
Connect the Ethernet cable to the PC J2 port
on the POE box and to the computer.
Apply AC power to the POE box. Wait approx.
45 seconds for the connection.
Start the ProViewer Software, and click the
Connect button to connect to the sonar.
User
computer
Ethernet cable
Benchtop Test Setup
110-240VAC
POE box
Sonar to
surface cable
Sonar
head
Bench Test the Sonar with VDSL
Connect the sonar as shown here.
(The various components may differ in appearance.)
Connect the RJ45 on the sonar cable to the
SONAR J1 port on the POE box.
Connect the RJ11 on the sonar cable to the
SONAR port on the VDSL box.
Connect the Ethernet cable to the PC port on
the VDSL box and to the computer.
Apply AC power to the POE and the VDSL
boxes. Wait approx. 60 seconds for the
connection.
Start the ProViewer Software, and click the
Connect button to connect to the sonar.
User
computer
Ethernet cable
Benchtop Test Setup
with VDSL
110-240VAC
POE box
25 ft sonar to
surface cable
VDSL topside box
RJ11
RJ45
Sonar
head
Mount the Sonar
The sonar head should be mounted looking forward, preferably on the
same pan-and-tilt as the ROV’s main camera.
Note: Your sonar might look different than the picture shown, but the same
concept applies.

M-Series Sonars (incl. Mk2)
Page 2 July 2020
© 2020 Teledyne RESON A/S. All rights reserved.
Use and Disclosure of Data
EU Uncontrolled Technology: Information contained herein is uncontrolled under the E.U. Regulation (EC) No 428/2009.
However, export, reexport or diversion contrary to law is prohibited.
Switching Sonar Heads
(M900/2250 sonar only)
When the Connect button is clicked, the
ProViewer software will automatically list
all sonar systems and sonar heads
connected to the PC.
Select the desired Sonar and Head from
their respective dropdown menus.
Sound Speed Calibration
If an image looks broken or misaligned, it is most likely
caused by an incorrect sound speed value. To access
the Sound speed slider from within ProViewer 4, right-
click anywhere in the imagery window.
Auto Intensity Controls
To access extra controls, remove the Auto Intensity check mark.
Shutdown
Close and save any sonar data files before removing the sonar power. When power cycling the sonar, allow
at least 10 seconds of ‘off time’ before turning the sonar back on.
User’s Manual
For details (on e.g. hardware trigger and PPS), refer to the user’s manual (provided on a USB key).
Support
For support, please contact:
Email: [email protected]
Hotline: Europe: [phone] / USA: [phone]