Teltonika TMT250 Installation and user guide

https://wiki.teltonika-gps.com/view/How_to_read_data_from_TZ-BT04/05/05B_sensor_with_TMT250_
device
How to read data from TZ-BT04/05/05B
sensor with TMT250 device
Main Page > Autonomous Trackers > TMT250 > TMT250 FAQ > How to read data from TZ-BT04/05/05B sensor
with TMT250 device
Contents
1 How to read data from TZ-BT04/05/05B sensor with TMT250 device
1.1 Solution applies for these SAS devices
1.2 Configuration
How to read data from TZ-BT04/05/05B sensor with TMT250
device
Solution applies for these SAS devices
| TMT250 | GH5200 |
Configuration
These are instructions on how to easily read data from TZ-BT04/05/05B Bluetooth LE sensor with
TMT250 device.
First the TMT250 device Bluetooth settings need to be configured. These are the required steps:
Press Bluetooth settings.
Turn on BT Radio by pressing Enable (hidden) or Enable (visible).
Press Bluetooth 4.0 settings.
Select TZ-BT04/05/05B sensor in BLE connectionless functionalities section.
Type your TZ-BT04/05/05B ID in ID field.
After all these steps press Save to device to save configuration.
To start BLE scan right away press Discover BLE.

More information about these settings can be found on TMT250 Bluetooth 4.0 Configuration modes
page.
To check if the TMT250 device has already received data from TZ-BT04/05/05B Bluetooth LE
sensor, follow these steps:
Navigate toStatus section.
Press I/O Info and look if BLE Temp, BLE Battery and BLE Humidity has any values.