Teltonika FMT100 User manual

Teltonika FMT100 GPS TRACKER INSTALLATION GUIDE
Additional configuration
notes if using the device
on our software platform.
1. Clean surface of vehicle battery.
2. Peel off sticky pad cover
3. Stick device to top of battery cable exit point towards front of the vehicle)
4. Connect Black wire to Negati e battery terminal.
5. Connect Red wire to Positi e battery terminal.

NOTES FOR SETTING IGNITION SENSE
There are 2 options for detecting ignition on/off
1. Board Voltage – Device automatically detects voltage change when engine
is switched on/off and sets the ignition status accordingly. (On some vehicles
this feature can provide false readings such as auto stop/start technology etc
in which case select option 2 (Movement sense)
2. Mo ement Sense – When the device detects movement it switched the
ignition status to on. If the device does not sense any movement for any 5
minute period it will switch the ignition status to off.
DO NOT SELECT #1 INPUT STATE
You will need to log into the tracking platform to set the method of ignition you
are using.

TRACKING INTERVAL SETTINGS
You can change the data upload settings in
the software platform. If connecting remote
immobilise feature we recommend setting
the ‘idle’ time interval to 30 seconds.
Always ensure you tick the bo marked
‘Enable the sleep mode on idle’ which
switches the GPS module off when parked
to preserve the vehicle battery charge level.
UNAUTHORISED MOVEMENT SETUP
The platform will automatically set up
unauthorised movement alerts. To prevent
false alarms from GPS drift we recommend
setting the minimum control start time to 5
minutes and the minimum distance to at
least 1000ft.

HARSH DRIVING MONITOR
You can alter the sensitivity for
the ‘harsh driving’ alerts in the
platform device settings tab.