Tennant M17 Series Training manual

IB 9016098 (12- 2017) 1
INSTRUCTION BULLETIN
No. 9016098
Machine: M17 / T17
Published: 12- 2017
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9016099
SYNOPSIS:
This kit contains instructions to convert the 36VDC/160A off board charger from 480 vac to 400 vac
for M17 / T17 machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 15 minutes)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
1. Press and hold the Enter / Power button on
the battery charger to power it up.
2. Press and hold the ESC (Escape) button to
enter the screen.

IB 9016098 (12- 2017)2
3. Press the four outer buttons as needed to
navigate through screens in the following
steps.
4. Navigate to “Password” then press the
Enter/Power button. Enter the password
0099thenEnter.
5. Navigate to “Settings” then Enter.
6. Navigate to “Power Supply” then Enter.
7. Select “400VAC” then Enter.
8. Press the ESC button to verify the correct
setting was selected. An asterisk (*) will show
next to active setting (*400VAC).
9. Press ESC then navigate to the “Exit” setting
and select it.
10.The charger is now set to charge 400VAC
batteries.