Tentipi IT Solo pitching kit User manual

www.tentipi.com
Before using the product, please read “Care instructions, hints and advice” at tentipi.com/support
IT Solo pitching kit
For pitching a whole or a half inner tent. The long fastening strap is only needed when
pitching a half inner tent.
Attach the top connector to the upper edge of the inner tent using
the O-rings and the eight toggles (ve for a half inner tent, see the
next page).
Use the mounting cross to position the pegs. Then attach a ground
tensioner to each peg.
Put the central pole inside the sleeve of the top connector and then
pitch the inner tent by pushing the pole upwards. Put it down in the
centre of the inner tent. Close the door and tighten all the ground
straps. Adjust the straps as required.
Attach the eight ground tensioners to the lower edge of the inner tent
using the O-rings and the toggles (ve for a half inner tent).
Top connectorLong fastening strap 8 x Ground tensioners
You also need
Measuring tape
Mounting cross
Tent pegs

www.tentipi.com
Before using the product, please read “Care instructions, hints and advice” at tentipi.com/support
IT Solo pitching kit, half inner tent
The IT Solo pitching kit can be used to pitch all models of
Base, Comfort and Pro inner tent, size 5, 7 and 9.
Attach the top connector to the upper edge of the inner tent using
the O-rings and the ve toggles.
There is a oor tensioner at each end of the long side of the inner tent.
Push the toggle at each end through the smaller ring on the ground
tensioner and then attach to the ring on the inner tent.
Fasten the O-rings on the three remaining top connector straps (the
ones at the front) to the snap-link on the long fastening strap.
Attach the fastening strap to the ground using a peg positioned
centrally some way in front of the half inner tent. Put the central pole
inside the sleeve of the top connector and then pitch the inner tent
by pushing the pole upwards. Put it down in the inner tent. Close the
door and tighten all the ground straps. Tighten the long fastening
strap as well so the half inner tent stands straight. Adjust the straps
as required.
Attach the other three ground tensioners to the lower edge of the
inner tent using the rings and toggles. Use the mounting cross to
position the ve pegs in a half-circle. Push the pegs fully down and
pull the ve ground tensioners over the pegs.