Tentipi Nordic tipi Guide

www.tentipi.com
Before using the product, please read “Care instructions, hints and advice” at tentipi.com/support
The canopy’s fastening is connected to the Nordic tipi’s
accessory sleeve. The eyelet and cord are used when
the canopy is put up as a freestanding shelter, see the
pictures on the opposite page.
Canopy 5/7 is mounted using a telescopic pole and a
cord and is tightened using another four cords.
Canopy 7/9 is mounted using three telescopic poles plus cords and is tightened
using two or four more cords.
1.Attach the canopy to the accessory sleeve. Press rmly all
along the Velcro strips.The canopy is mounted on the right so
that rain water is led away from the tent opening.
2. Pull the eyelet at the front end of the
canopy over the end of a telescopic pole
and peg the cord to the ground. Canopy
7/9 has three poles.
3. Peg the other cords to the
ground. Adjust and tighten so the
canopy ts snugly against the tent.
Mounting the canopy onto the Nordic tipi
The canopy is not intended to resist strong winds and snow. The exceptional storm resistance of a Tentipi® Adventure Nordic tipi
is maintained by the canopy being designed so that it can easily be removed in bad weather.

www.tentipi.com
Before using the product, please read “Care instructions, hints and advice” at tentipi.com/support
Freestanding canopy
Putting up the canopy as a shelter or freestanding
Shelter
First of all, put a tent peg in the band loop on the side opposite the side with the Velcro fastening. Push the end of a telescopic pole through the
eyelet by the Velcro fastening and adjust it to a suitable height. Peg the cord down and tighten it. Place tent pegs along the long sides. Canopy 5/7
has band loops for two tent pegs on each side while Canopy 7/9 has band loops for three tent pegs on each side.
Freestanding canopy
It is easier to be two people when putting up the canopy like this. One person pushes a telescopic pole through the eyelet by the Velcro fastening
and pegs the cord to the ground. While the same person holds the telescopic pole upright, the other person attaches a telescopic pole plus cord
on the opposite side. For size 7/9, two poles are needed on this side and it is also possible to put a third telescopic pole here, in the same
way as when the canopy is mounted onto the Nordic tipi. The cords on the long sides are pegged down and all cords are then adjusted using
their tensioners. Canopy 5/7 is xed in place using two cords on each long side while for Canopy 7/9, it may be enough with one cord on
each side, thanks to the extra telescopic pole.
There are two cords on each long side of Canopy 7/9 as well which can be used if more stability is required.
Canopy 5/7, lightweight model, put up as a freestanding canopy Canopy 7/9 put up as a freestanding canopy
Canopy 5/7 put up as a shelter Canopy 7/9 put up as a shelter