Test Equipment Depot Fieldpiece HVACR User manual

Right Shoulder Setup
(Default)
Left Shoulder Setup
1
2
3
Flip the Strap to
Switch Shoulders
1. Flip Top Buckle
Unbuckle the top buckle of
the shoulder strap. Flip it and
snap it back in.
3. Move the Small
Buckle to the Front
Slide out the small buckle from the
shoulder strap so you can put it onto
the other side. This smaller strap
doesn’t ever need to be unbuckled.
2. Swap Straps
Swap the two strap hookups
located at the bottom corners of
the bag.
The strap system is reversible so you can carry it on either shoulder.
Fieldpiece HVACR
Service Tool Bag
BG44
Congratulations. You’ve purchased a tool bag designed specifically for HVACR professionals. The single
strap system is easy to get on and off, while the padded side pockets protect your test instruments and
provide easy access.
The interior tool rack houses hand tools for easy access and quick visibility so missing tools don’t get
left behind. Special accessories include a magnetic tray, water bottle/ wasp spray strap, electrical tape
strap, small plastic tray storage in bottom, and drill holster. All in a compact bag that fits snuggly to the
body to fit in tight places like crawl spaces and ladder cages.
To get the most out of this bag, please take a few moments to see that “there’s a place for everything
and that everything has a place”for the most common HVACR tools used in the field -- everyday.
Patent Pending
99 Washington Street
Melrose, MA 02176
Phone [phone]
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com

Adjust the Velcro strap and
cinch your water bottle or
wasp spray.
The tool rack is labeled so you
know where your tools go. The
padded side pockets protect
your Fieldpiece Instruments.
Open the cinch strap and
connect to your drill handle.
Hold cabinet screws, nuts,
and washers on the top of
your bag.
Load Your Tools
Store your test tools separate from your hand tools. The main compartment contains
the tool rack for drivers and pliers. Pockets behind the rack hold your wrenches. The side
pockets are padded with space for 2 meters on each side.
Tool Rack &
Side Pockets
Water
Bottle Strap
Magnetic
Tray
Drill
Cinch
Side Panel Top
Tape measure
Front Pockets
Hex key sets, accessories
Rear Rack Row
Nut drivers, large shanks
Middle Rack Row
Small shanks, multi driver
Pockets Behind Rack
Wrenches, ratchet sets
Front Rack
Pliers, cutters
Loaded Tool Rack
Wear It Across Your Chest
This new bag strap is different and easier than a typical two strap backpack.
The single large strap distributes the load across your chest.
Slip your bag onto your shoulder, NOT over your head.
1. RIGHT SHOULDER
Slip your right arm through the
opening between the shoulder strap
and support strap.
2. SNAP
Bring up the big hanging buckle to
snap it into the main should strap.
3. CINCH
Cinch the shoulder strap nice
and tight!
Single Strap System
DO NOT place strap over your head.
DO NOT disconnect the small support strap.
Step 1
Step 2
Step 3
That’s it!
Patent Pending
See back for directions on switching to left shoulder.