The Handy S.A.M.2 User manual

ITEM # 16900G - 16900O - 16900R - 16900B
1. Center load on table - 1000 lb. maximum.
2. Connect to 110 psi maximum shop air.
3. Keep safety bar in position at all times - except
when lowering.
4. Keep hands and tools from under carriage.
5. Do not mount table when in elevated position.
6. Do not ride vehicle onto lift.
7. Lift must be in the lowered position when moving.
8. Only trained persons should operate Air Lift.
9. The working area should be sufficiently lit.
10. Foot controller should be at least 3 feet away from
Air Lift during raising and lowering operation.
11. Recommended for indoor use only.
12. Tie-down straps must be used in conjunction with
the holes provided in the lift top.
S.A.M.2 1000 AIR LIFT
INSTRUCTIONS PARTS DRAWING PART LIST

UNPACKING AND SET-UP
1. Open carton, then remove ramp, drop panel and shipping boards.
2. CAREFULLY TURN TABLE UPRIGHT INTO OPERATING POSITION BEFORE REMOVING SHIPPING
CABLE RESTRAINT FROM SCISSOR MECHANISM.
3. Remove the two shipping bolts attaching rear drop panel to lift top. The bolts are located under drop
panel and lift top at each end.
4. Connect foot-operated air valve to 110 psi maximum air supply. The lift may be damaged and/or personal
injury may result if the pressure exceeds the maximum 110 psi rating.
5. Stand clear of lift table, and depress the UP side of foot valve to raise table.
6. To lower table, lift detent bar from safety latch and lower to next position or to floor.
7. To level front or rear drop panels: adjust set screws up or down through access holes in each corner of lift
top to gain level work platform. See print.
8. Slide front & rear drop panels into place and lift to lock in place at end of tube.
9. Insert ramp mounting tabs into slots at either end of table to mount ramp.
NOTE: If cycle vise is being installed, ramp must be mounted opposite the cycle vise.
OPERATION
1. Loads must be centered on table at all times. Table is rated for a maximum load of 1000 lbs.
2. Loads must be firmly positioned and secured on table at all times. Tie-down straps must be used
in conjunction with the holes provided in the lift top.
3. All moving parts have been lubricated at the factory and should be re-lubricated every 6 months to prevent
galling. Grease zerks are located at each end of frame pivot shaft and at
top ends of inside frame assembly.
4. Lightly oil cylinder rod when it becomes dry.
5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every 6 months.
6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top end of the inside frame assembly.
OTHER OPTIONS AVAILABLE
Separate installation instructions included with each option.
14476
CV-17 CYCLEVISE–Used to stabilize motorcycle while on lift
16901
10” SIDE EXTENSIONS – ( 2) Expa nds width of lift to a full 48”
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS.
DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS
ARE FOLLOWED CAREFULLY.

PARTS DRAWING - PARTS LIST
Shop for other garage accessories on our website.